Electronics Forum | Mon Oct 17 13:02:28 EDT 2016 | tdemon69
i have a MPM2000 now giving me 0 - hardware limit warnings..let me start off by saying that is was giving me x axis limit problems, so i replaced the x card with diff card. set all the switch and jumpers to x card , then i got 0- hardware . so then
Electronics Forum | Thu Jan 19 18:11:45 EST 2023 | atpico
My UP2000 HiE Printer on Power-ON during initial Reset will show this error and reset will abort with no way to continue. E00938 10 - HARDWARE LIMIT WARNING In Input/Output Screen all Sensors are in normal situation and will react normally when t
Electronics Forum | Wed Jun 02 15:29:47 EDT 2004 | pr
Make sure the board is stopping at the center of the worknest or you will waste lots of time (you'll get software limit errors when you try to find fids.). If it's not in the center, you need to go in and reteach from scratch (doesn't take too long).
Electronics Forum | Sat Jan 21 10:28:16 EST 2023 | compit
The so-called "drivers" are used to control each servo - control boards at the back of the machine. There are several (8?). If one is "worn out" and has no strength to move the servo, maybe this is where the error comes from? They can be interchanged
Electronics Forum | Fri Apr 29 15:17:54 EDT 2022 | glasscake
If the machine was working appropriately before the hard drive failure i would lean on the issue being a configuration issue. Lots of machines have options in their software for different sized motors, limit sensors, IO configs, ext. See if you cant
Electronics Forum | Fri Sep 22 08:37:47 EDT 2006 | john
Using MPM UP2000 Hie printer.When give cycle wiper command,After comleting forward stroke machine gives error wiper not parked,press next to continue.If press NEXT VY axis software limit comes and machine give message press NEXT to continue.IF press
Electronics Forum | Tue Mar 28 19:28:54 EDT 2017 | aemery
Giao, These style of MPM's use stepper motors, but no feedback like an encoder or a resolver. In other words all axis positions are assumed after "Reset" of the machine. Because of this style of drive system there is the potential for the vision ga
Career Center | Wesley Chapel, Florida USA | Engineering,Management,Quality Control
15 years of experience on Electronic Manufacturing. Certified SMT Process Engineer TQM Knowledge Statistics DOE Screen Printer Thermal Process Knowledge JIT International Project Engineering Experience
