Electronics Forum | Mon Apr 28 21:51:56 EDT 2014 | elabcircuits
Hello, We have a MPM UP2000 HiE printer from 2000, software version 7.2E. The PC board is not booting anymore (black screen), no drives spinning. It's an Advantech 486SX version. Question: would a Pentium 3 SBC (Single Board Computer) with ISA
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Wed Dec 28 18:09:47 EST 2022 | atpico
Second question concerning MPM UP2000HiE: Are there two options of conveyor lengths for this printer? Looking for conveyor belts spare parts I found two options: One 137" and one 106" that gives about 134 and 174cm total conveyor lengths. Does any
Electronics Forum | Mon Aug 28 12:07:15 EDT 2006 | cyber_wolf
We are looking into purchasing a used UP-2000 Hi-e. We are high mix /high change-over. The machines I am looking at are equipped with the grid-lok system. Can anyone give me pros's/ con's ?? Thanks in advance. Sr.
Electronics Forum | Sat Sep 02 07:38:43 EDT 2006 | cyber_wolf
We have decided to go with a UP2000 Hi-e with the newer generation Grid lok. This is a refurbed machine with a warranty.
Electronics Forum | Tue Aug 29 21:14:45 EDT 2006 | Bubba
You need a machine with side clamps. DEK makes them. MPM makes them. Look into a retro for your machine. Both take up space on top of your board. Be carefull of top side component clerance if switching.
Electronics Forum | Mon Sep 04 16:07:38 EDT 2006 | C.K.
Grid Loks & Gels ain't my forte, but when it comes to JNJ Support Plates for the MPM, (http://www.jnj-ndustries.com/PDFFiles/Techno%20Talk/Vol.%20VI%20-%20WEB%202003.pdf) and Quantum Physics....I'm your man.
Electronics Forum | Thu Aug 13 19:51:47 EDT 2009 | prasadz
Jagadeesh Rajagopalan is the expert in MPM Screen printer Servicing and he suggest to do the calibration of Z axis with PCB thickness (1.3mm)
Electronics Forum | Wed Mar 30 17:58:18 EDT 2022 | proceng1
I think I have UP1500 SW. Not sure if it's the same. I also have Accuflex SW, which is pretty similar to UP1500
Electronics Forum | Thu Aug 31 00:08:54 EDT 2006 | jasmin
Hi Sr Tech, You can contact by email address : sales@baoding.com.sg for the quotation that i send to you earlier. Thanks & Regards Jasmine
.jpg)
