Electronics Forum | Wed Mar 30 18:00:27 EDT 2022 | compit
If you do not find it until Monday - write. I have one, but I won't be at work until Monday, maybe I'll help.
Electronics Forum | Wed Mar 30 21:08:11 EDT 2022 | rdssmt
Thanks, if I dont find it, I wiil be send email. Regards.
Electronics Forum | Mon Apr 04 17:13:36 EDT 2022 | rdssmt
Michal good morning. Can you helping with the software and send me the cost please. Regards.
Electronics Forum | Mon Apr 04 20:09:18 EDT 2022 | compit
Tomorrow I will try to rip from the computer. Today I have 22 PM.
Electronics Forum | Mon Apr 04 21:38:26 EDT 2022 | rdssmt
Email. Ricardo.duran@duro-manufacturing.com rdssmt@yahoo.com.mx Thanks.
Electronics Forum | Thu Dec 29 18:44:36 EST 2022 | compit
Yes, there are two lengths. My MPM UltraPrint 2000 HiE has trays protruding from the machine about 15 cm, I think. I'll check with the company tomorrow to see if there are any numbers in the manual. I have a link to the part saved - maybe check it ou
Electronics Forum | Fri May 05 21:10:41 EDT 2023 | zsoden
Hi ELC, I'm curious about your comment of calibrating the Z axis. Our UP2000 has been moved around a few times and we've never done this nor noticed a need to. Could you please share some more information and even perhaps the calibration procedure?
Electronics Forum | Fri May 04 14:47:15 EDT 2007 | jasont
Chris, I have x2 units available in my Brockville, Canada warehouse now. They are off MPM UP 2000 HiE's and the model #'s are as follows; MCU012A-SOO AP25-917A Please e-mail directly at jason@tekmart.com Looking forward to your reply, Jason
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Tue Aug 29 14:21:24 EDT 2006 | billyd
Dude: I have used the Grid-lok system before, in DEK 265 and DEK Infinity printers (clamps) and they worked quite well. But, we did have the side clamps. I'm not sure how that translates to an MPM. They were the best we could find as far as the