Electronics Forum | Wed Aug 30 23:58:53 EDT 2006 | jasmin
We are looking into purchasing a used UP-2000 > Hi-e. We are high mix /high change-over. The > machines I am looking at are equipped with the > grid-lok system. > > Can anyone give me pros's/ > con's ?? > > Thanks in advance. > > Sr. Hi Sr T
Electronics Forum | Thu Sep 07 09:04:24 EDT 2006 | Doug Eidle
Hi, First off, I am the Pre Owned Equip. Business Mgr. for Speedline Technologies. We have a factory Renewed (our enhanced refurbishment process) available. You can contact your local Speedline MPM Rep for price and information. If board warp is
Electronics Forum | Thu Aug 31 19:40:22 EDT 2006 | cardinal
A couple things on the Grid-Lok system. They now offer a top-side edge clamping system. The edge clamping system works very well for warped, twisted boards etc.. Using this system in the auto mode also allows the pins to contour to the geography of
Electronics Forum | Tue Aug 29 10:36:09 EDT 2006 | Chunks
With the UP2000 that has vacuum board hold down, the Grid Loc hoses defeat the vacuum in order for them to exit the work table. Big boards require more girds, thus more hoses. Set-up between large and small boards takes time to remove or add the gr
Electronics Forum | Fri Sep 01 01:18:37 EDT 2006 | cardinal
How many of these printers have sold in the last three years? I have sold over 40 in the last 18 months. You can claim all the numbers you want. If you have the units to sell at $25K; then sell them. If you are selling them at $25K, you are selling
Electronics Forum | Thu Aug 31 21:43:13 EDT 2006 | fastek
I don't sell them for $25K either but my point is they can be had for that price. In fact the last (2) that I had I purchased for $8K and $9K. I never have claimed to be the cheapest dealer around and it's not my intention......I only intend to be
Electronics Forum | Tue Sep 05 16:26:53 EDT 2006 | Bill
Thinking about this auto-mode on Grid-Lok..... Ok, the board is warped, lets say positively, the pins conform to the warped board... what about the effect on top side and squeegee pressure? It will be much higher and could damage stencils, right? Pos
Electronics Forum | Thu Aug 31 18:58:37 EDT 2006 | chrisgriffin
Fastek, You are correct. I know of machines you can get for 25k that are in working condition. But if I was going to buy one used, I would want it refurbished and calibrated. I would also be interested in support and warranty. I don't know of an
Electronics Forum | Tue Aug 29 11:34:42 EDT 2006 | pr
WOW, for having never spent more than a drive by with the units and NEVER having set it up or used it, you are a wealth of info. who say's you can't learn anything from the fine smtnet archives? You definately have bean bags on the chin (mind) cause
Electronics Forum | Fri Sep 08 16:12:38 EDT 2006 | Buzz
NO! We need to try to initiate the description of the criteria for requirements by developing a framework for the application architecture consistent with the planning corridor specified in our strategic initiative. Once bilateral goals are establi
