Electronics Forum | Sat Feb 16 16:14:20 EST 2013 | ericrr
Have you done a post-mortem on the blown fuse? Assuming it is a glass fuse, if it is all black around the glass then replacing the fuse will be pointless. (the new fuse will just blow again, making a black mark or BLACKER mark all around the glass)
Electronics Forum | Fri Oct 04 13:14:13 EDT 2019 | ddfreeze
I need to access the calibration menu, does anyone have a password for it? having issues with the z axis hardware limit. doesn't appear the card is bad. board raises to camera and goes back down???
Electronics Forum | Thu Oct 21 11:15:00 EDT 2010 | jorge_quijano
Do you know in which axis the problem occurs? usually when "hardware limit error" shows is because one of the axis touches the sensor of the limit, this is to prevent the mechanism hit something, If you machine is used, you can check if there is a mi
Electronics Forum | Thu Oct 20 10:29:45 EDT 2011 | babe7362000
Can anyone tell me what a Tactile 12-Hardware Limit Warning is on the MPM Up2500? I tried to reset the machine and it gets stuck on the Tactile. If anyone can help, I would appreciate it. Thanks
Electronics Forum | Mon Oct 17 13:02:28 EDT 2016 | tdemon69
i have a MPM2000 now giving me 0 - hardware limit warnings..let me start off by saying that is was giving me x axis limit problems, so i replaced the x card with diff card. set all the switch and jumpers to x card , then i got 0- hardware . so then
Electronics Forum | Wed Jul 19 07:27:09 EDT 2023 | roachindignant
This problem appears whenever I turn on my UP2000 HiE printer and try to perform the initial Reset. Hardware Limit Warning (E00938:10) All sensors on the Input/Output Screen are functioning appropriately and will give expected results when checked
Electronics Forum | Fri Sep 22 08:37:47 EDT 2006 | john
Using MPM UP2000 Hie printer.When give cycle wiper command,After comleting forward stroke machine gives error wiper not parked,press next to continue.If press NEXT VY axis software limit comes and machine give message press NEXT to continue.IF press
Electronics Forum | Thu Oct 20 13:34:08 EDT 2011 | babe7362000
I checked the housing and it can move up and down freely. I went into Cal and also moved it without a problem. The sensors in the digital I/O seem to be fine. I checked the voltage going to the driver card and it seems to be fine. I think I will s
Electronics Forum | Tue Nov 25 18:39:59 EST 2014 | rhcriad
We have an MPM UP2000 stencil printer and have a lot of issues with burned out 6410 driver cards (or driver cards just failing to work). I have looked over these threads and found that this is a common issue with these cards. I understand that thes
Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a
.png)
