Career Center | Waterloo, Ontario Canada | Engineering,Research and Development
**To apply please send your resume to clapierre@rim.com** Research In Motion Limited� (RIM)� is a world leader in the mobile communications market and has a history of developing breakthrough wireless solutions. RIM's portfolio of award-winning prod
Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Mon Oct 20 15:28:22 EDT 2014 | island2013
We've got a set of manuals here for the AP series. If you would like to borrow them email me.
Electronics Forum | Sun Oct 12 22:08:34 EDT 2014 | cusackmusic
I just got a used AP/C which I guess is also called an AP25? After fixing a few obvious issues, I powered it up, and get a hardware limit error. I have verified that none of the axis are near their limits. Without a manual, I'm not sure where to go
Electronics Forum | Tue Oct 14 10:52:35 EDT 2014 | swag
Can't help you with the manual but do have some tips: If it was shipped, it's possible someone tied axis or blocked stuff for shipping. Look for that. Look for bent sensor flags + go into I/O and check to see all sensors you can find are working.
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Fri Sep 24 06:17:47 EDT 2010 | bullyparade
Hi all, we use a MPM UP2000/B printer and facing the following problem: During startup/initialisation process the printer stops after a while and comes up with the following alarm "hardware limit warning". This can be repeated several times with the
