Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Thu Dec 29 18:51:16 EST 2022 | compit
Standard 51" (1295.4mm) Optional 66" (1676.4mm)
Electronics Forum | Thu Dec 29 18:44:36 EST 2022 | compit
Yes, there are two lengths. My MPM UltraPrint 2000 HiE has trays protruding from the machine about 15 cm, I think. I'll check with the company tomorrow to see if there are any numbers in the manual. I have a link to the part saved - maybe check it ou
Electronics Forum | Wed Dec 28 18:09:47 EST 2022 | atpico
Second question concerning MPM UP2000HiE: Are there two options of conveyor lengths for this printer? Looking for conveyor belts spare parts I found two options: One 137" and one 106" that gives about 134 and 174cm total conveyor lengths. Does any
Electronics Forum | Wed Dec 28 11:05:27 EST 2022 | atpico
We have 7.2E (MS-DOS variant) software version on our printer and there are some annoying bugs and less than optimal NPI process (when the new board need to be put on and put off the rails several times during NPI teaching). Is there a known newer/be
Electronics Forum | Thu Dec 29 14:09:45 EST 2022 | proceng1
Your best source of parts and info for MPM machines is PPM in New Hampshire. George, who is the oracle when it comes to these printers is no longer with the company, but either Ed Sullivan or Steve Brown can probably assist you. I had a UP1500 and
Electronics Forum | Wed Mar 30 16:55:44 EDT 2022 | rdssmt
Hi, I have a Screen Printer MPM UP2000 HI-E machine that the software is not working; Does anyone have the software that can sell it to me or even a hard disk with the software? Thanks.
Electronics Forum | Fri Mar 29 16:17:47 EDT 2013 | aemery
Sorry I am late on this thread, just became a member and was scanning through the posts. I am a former FSE for Speedline, now independant, so all this stuff is my bread and butter. Here are some facts that could help you all in the future. MPM pri
Electronics Forum | Fri Sep 22 08:37:47 EDT 2006 | john
Using MPM UP2000 Hie printer.When give cycle wiper command,After comleting forward stroke machine gives error wiper not parked,press next to continue.If press NEXT VY axis software limit comes and machine give message press NEXT to continue.IF press
Electronics Forum | Thu Jan 19 18:11:45 EST 2023 | atpico
My UP2000 HiE Printer on Power-ON during initial Reset will show this error and reset will abort with no way to continue. E00938 10 - HARDWARE LIMIT WARNING In Input/Output Screen all Sensors are in normal situation and will react normally when t