Electronics Forum | Thu Jul 06 12:23:43 EDT 2023 | poly
On my one and I think all of them you need to do it manually. Send the stencil shuttle to front, There's two hex screws either side (4 total) you need to loosen. There a little indicator for the different common sizes. Then send the shuttle to the
Electronics Forum | Thu Aug 07 09:24:42 EDT 2014 | tombstonesmt
Good morning everyone! I'm searching through tech sheets and equipment manuals to determine the recommended paste thickness on the stencil during operation. We use a MPM momentum screen printer using SAC305 paste. Board isn't too complex; one QFP, co
Electronics Forum | Mon May 02 08:32:50 EDT 2005 | jh0n!
We recently bought a used MPM UP1500 to upgrade from a manual DeHaart printer we'd been using for years. On the DeHaart, all of our stencils were 15" square. We purchased at auction a stencil adapter for an MPM printer (ie: 29" wide), however it's
Electronics Forum | Fri Jul 27 09:28:35 EDT 2007 | rich7799
I have Mpm ap25hie, s/w ver 7.1a The problem I have is that the machine works fine until I teach or use the pre board stop function. As soon as I use this the machine will not load the pcb to the centre of the work nest. I can manually change boardst
Electronics Forum | Mon Oct 01 11:57:34 EDT 2007 | kpm135
I've never worked with a MPM printer but I had something similar happen on a DEK printer. The problem was that screens were manually centered in the machine and the operators were not careful enough when setting it up so the settings were very close
Electronics Forum | Thu Nov 21 20:23:26 EST 2013 | dandin87
We have a Speedline MPM UltraPrint 500. The Hard drive currently in it has bad sectors, and so I had tried to install a new hard drive and used the installation folder from the old one to re-install SigmaPro 32. When I start it fails to find the Mete
Electronics Forum | Wed Jul 01 05:33:29 EDT 2020 | zsoden
I recently purchased a used MPM UP2000 printer that I'm getting up and running. It's in very good condition and other than a worn out auxiliary on the main power contactor seems to be all working correctly. I've got it operating in demo/dry run mode
Electronics Forum | Sat Apr 09 13:42:03 EDT 2005 | jh0n!
how funny... we just bought a up1500, no manuals/install cd, and we need to do the same thing. i was hoping that by removing /sigpro/user.pwl and /sigpro/permis.lst, and all references to them in sigpro.ini and sig1500.ini it'd let me in, but no luc
Electronics Forum | Thu Jul 07 09:53:17 EDT 2005 | PWH
Agree with D.B. We have also had to replace the belt that runs the auto conveyor width function. It might look just fine, but it will skip teeth on occasion if stretched or worn. Reparallelling the conveyor rails can be done manually by skipping t
