Electronics Forum | Thu Feb 21 08:20:43 EST 2013 | cowens
Thank you so much. We actually did get the machine up and running yesterday morning. We switched the theta and the transport driver cards and it is working now. We have had the connectors burn on us in the past and replaced them. I am hoping the prob
Electronics Forum | Tue Mar 28 19:28:54 EDT 2017 | aemery
Giao, These style of MPM's use stepper motors, but no feedback like an encoder or a resolver. In other words all axis positions are assumed after "Reset" of the machine. Because of this style of drive system there is the potential for the vision ga
Electronics Forum | Fri Mar 29 16:17:47 EDT 2013 | aemery
Sorry I am late on this thread, just became a member and was scanning through the posts. I am a former FSE for Speedline, now independant, so all this stuff is my bread and butter. Here are some facts that could help you all in the future. MPM pri
Electronics Forum | Tue Sep 26 10:22:51 EDT 2006 | SWAG
Histogram: Place standard tooling block in centernest. Jog camera over block. Jog z-axis to soft limit. Place a white card under camera. User mode to test. Turn board lamp on. From test menu, select histogram. With board lamp on and white under camer
Electronics Forum | Fri Mar 18 15:02:07 EST 2005 | pmd
Please clarify, Z axis gears (Blades)? The MPM head I believe is what your are asking is driven up and down via a lead screw. The machine gets the zero point from the "HAT" tactile sensor in the table nest. When squegees are installed the blades are
Electronics Forum | Tue Nov 25 18:39:59 EST 2014 | rhcriad
We have an MPM UP2000 stencil printer and have a lot of issues with burned out 6410 driver cards (or driver cards just failing to work). I have looked over these threads and found that this is a common issue with these cards. I understand that thes
Electronics Forum | Mon Oct 02 10:25:49 EDT 2006 | SWAG
Daxman, Try this: - it might help your histogram. The camera may be operating production reads at or close to the z-axis drive limit but you don't know really. Write a dummy program that will allow you to load a PCB into the centernest at vision h
Career Center | Bangalore, India | Engineering,Management,Production,Quality Control,Technical Support
WORK EXPERIENCE DETAILS: 7+ Years of Experience in manufacturing & hardware testing of Protocol conveter & Commissioning, Products delivery and QA/QC. 2+ Years of Experience in Hardware testing and Package Level testing. 2+ Years of Experience in