Electronics Forum | Mon Feb 07 02:38:00 EST 2011 | rodrigo
No, thanks.
Electronics Forum | Sat Mar 29 10:04:03 EDT 2014 | josse
Hello there everyone! Our company just bought an AOI Inspection Machine, and that is the Mirtec MV-2HTL 1.3 megapixel, software rev 4. I am trying to create a program that runs the top side first and then asks to run the bottom side consecutively. I
Electronics Forum | Wed Jan 19 12:54:17 EST 2011 | bdamico
Hello Mark, The centroid data you are currently using to program the MV-2HTL may be used with either platform. However, the libraries cannot be shared due differences in camera resolution. The MV-2HTL will have a 1.3 megapixel camera versus the 2 m
Electronics Forum | Fri Feb 04 18:41:26 EST 2011 | bdamico
Hello Rodrigo, I am sorry, but this is not the appropriate forum to discuss these matters. Please contact MIRTEC directly regarding your request (203)881-5559. Thank you, Brian D'Amico - President MIRTEC
Electronics Forum | Fri Mar 04 18:08:26 EST 2011 | eadthem
There is a option to enable no good marking that must be enabled on the board options where you reset your board count and images. dose the marker zero on startup?. If not then it may also need enabled in the inspector settings. ead
Electronics Forum | Mon Apr 23 22:27:14 EDT 2012 | padawanlinuxero
I have a MV-2HTL and we don't have problems with it. Have you try to contact Mirtec ? probably is a problem with the camera.
Electronics Forum | Fri Apr 04 21:16:56 EDT 2014 | padawanlinuxero
Same option is in the MV-2 Open both programs and then run one of them after inspection turn the board and press start it would change to the other program with no problem.
Electronics Forum | Sat May 14 12:32:33 EDT 2016 | dilogic
Depending on the vision, there might be issues with small black parts (like 0402 resistors etc.) - we have Mirtec MV2-HTL, btw.
Electronics Forum | Mon Oct 24 16:10:07 EDT 2005 | Brian Davis, Compex Technologies
Dear Colleagues, We are looking at entry level AOI solutions. We are currently evaluating the Mirtec AOI MV-2HTL. We are also looking at Vitech because of their perceived "edge" in the industry. I know that this forum has approached this question be
Electronics Forum | Wed Apr 23 10:19:53 EDT 2008 | mikesewell
Has anyone tried to increase the working height on their Mirtec AOI. We have several MV-2HTL machines and have a few boards that are over 2" tall. I'd rather not leave the parts out and have a secondary step to install them after inspection. I've
.png)
