Electronics Forum | Tue Apr 26 03:26:21 EDT 2016 | spoiltforchoice
Hah I meant to say that too, depending on the exact requirements you may even be able to do this with something cheaper than A MY600/Scorpion. Plenty of printers these days can dispense paste as can pick and place machines and small dedicated units.
Electronics Forum | Fri Oct 06 18:25:28 EDT 2017 | vchauhan
Has anyone used Mycronic (MYDATA)MY700 or MY600 Jet printer for solder paste printing? We are looking to buy one. Would love your feedback. Specially how the machine works, what it can do and are there any quality problems after printing with jet pri
Electronics Forum | Tue Dec 23 09:13:12 EST 2014 | jeff701
I'm in a manufacturing environment with a very high mix of boards, and some low-mid volume. A "large" production run might consist of 100 boards. Volume: There are numerous boards that have a volume of 1-3 pieces. There are a few boards with an annua
Electronics Forum | Thu Jan 08 17:36:02 EST 2015 | jeff701
The machine supports indexing, so it'll do one part of the board, advance it to a stop, read fiducials in the second stage of the board, and then paste that section. The MY500/600 reportedly do not support this feature, though there are usually ways
Electronics Forum | Fri Jun 09 16:01:27 EDT 2023 | atpico
Does anyone has any information about MY500 End Of Life and Spare parts availability? Are MYCRONIC MY600 cartridges backward compatible with MY500 ? Does these machines wear well? General reliability opinions? Thank you in advance. Hello again, f
Electronics Forum | Mon Feb 01 09:17:45 EST 2016 | spoiltforchoice
You can buy an awful lot of stencils for $200K > but where/how are you going to store all of those > stencils? There is a certain $$$ value to all > the space it will take to store them. > > I have > been told by a Mycronic salesman that they a
Electronics Forum | Mon Jan 25 17:58:22 EST 2016 | spoiltforchoice
I think its sufficiently niche that the only similar product is the Essemtec Scorpion, which is cheaper and slower. However depending on just how low volume you are Essemtecs platform can also pick and place on the same machine (albeit with few jet n
Electronics Forum | Thu Jan 28 09:21:48 EST 2016 | cyber_wolf
I would challenge anyone to present a legitimate cost justification on one of these machines that was not related to a very specific product/project. In other words I want to see what the advantage is $$ wise purchasing this machine over a screen pr
Electronics Forum | Wed Mar 02 02:07:06 EST 2016 | mbass
3000 components per side and yes the actual print cycle is longer (13 minutes) against the DEK print stroke of 30 seconds. But overall the whole cycle time of set up etc is way less on the MY500. The ability of the machine to adjust volume of paste o
Electronics Forum | Tue Feb 04 03:22:15 EST 2020 | tamasmagyar
You can do some changes on the fly on the machine, but is very limited. Like deleting a board from the panel, modifying offset, modifying fiducials etc. The thing is, I have issues with the programming interface, because the crashes and errors I get