Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Tue Oct 25 15:03:48 EDT 2011 | sjs2303
Hi Bert, For your second issue, are the tools well lubricated? If not the Midas head can fail to grab the tool and can generate the z motor error. Doing this followed by a base-centre level measurement should resolve your problem. Steve
Electronics Forum | Wed Jul 18 14:55:30 EDT 2012 | mikesewell
We bought from Mydata and recently had a new Midas head put in by Mydata and I've been on the phone with tech support. This has been a intermittent issue that's been hard to pin down.
Electronics Forum | Tue Aug 28 11:03:40 EDT 2012 | mikesewell
The problem is still intermittent. It has a new MIDAS head, installed and calibrated by Mydata, FWIW. Usually we work around it by moving parts upstream (Fuji AIM). I'll post an update when I finally chase the issue down.
Electronics Forum | Fri Jan 05 17:21:54 EST 2024 | tomdegas
The issue is with the Midas head. It gives me the same error with any tool I try to install.
Electronics Forum | Fri Dec 04 09:09:46 EST 2009 | bandjwet
We are considering purchasing an MY-19 refurbished from the factory. We were not initially looking at this model but it became available. Are there any issues with this model. (We already have an MY-9 and are familiar with the MYDATA and their suppor
Electronics Forum | Wed May 26 17:04:34 EDT 2010 | emrtech
the jaws are not for electrical testing do to being two solid stainless steel pieces. i dont really have any issues with 0402's, i got them placing good. its the 0201's that are a pain. attached is a picture of the centering jaws for you to see.
Electronics Forum | Mon Oct 21 11:05:57 EDT 2019 | tey422
With the given update you provided, that would rule out the nozzle tool issue. If the parameter looks fine, then the issue would be somewhere around the nozzle tool bank. Need to check open and close release. If the nozzle seats flush "not tilted" w
Electronics Forum | Wed May 26 13:17:32 EDT 2010 | emrtech
FYI we also found a set of centering jaws that were up for sale at http://www.mybidpage.com these were also modified and made of stainless steel. the guy a bought the jaws from also said, he would be posting more up for sale after getting them back f
Electronics Forum | Fri May 13 21:47:17 EDT 2022 | mikevb
I just received replacement XWB3 and 3PT1 boards. I swapped them out and it seems to have fixed that issue. Thank you all for the help!
