Used SMT Equipment | Pick and Place/Feeders
2009 Mydata MY100DX Placement System; SN: 140063; Dual Hydra Head, and Dual Single Midas Head, DVC (Dual Vision Camera), LSC (Linescan Camera; (2) Sets Hydra Mount Tools; Midas Mount Tools; Includes: Y Tray Wagon, Manuals This will be included in a
1.jpg)
Used SMT Equipment | Pick and Place/Feeders
Vintage: 2002, Software rev: 2.5.4, Configured with: 2 Pole Electrical Test, LSC: Line Scan Vision System, DVC: Dual Vision System Optical Centering, Autoteach, 500T Y-wagon (internal conveyor) Midas head, 21K Hydra ER Head - With Automatic Tool c
Industry News | 2005-02-17 09:43:45.0
STOCKHOLM, Sweden, Feb 14, 2005
Industry News | 2006-03-01 22:11:48.0
After its highly successful debut at the Productronica trade show in November, the MY500 Jet Printer will go on display at locations throughout Europe enabling busy and time-conscious manufacturers take a closer look.
Electronics Forum | Tue Feb 03 10:44:56 EST 2009 | lmartenson
We have been having problems placing a domed LED with a Mydata HYDRA. The pocket that the part comes in seems to have some slop causing the part to be picked crooked. We have been playing around with different custom tools. Has anyone had similar
Electronics Forum | Tue Feb 03 15:28:36 EST 2009 | kpm135
I agree, I'd try placing them with the midas or z-fi head depending what you have. Try using the mechanical centering in the zero angle with a low strength to move it straight. You'll probably have better luck finding a tool that will work on the hea
Electronics Forum | Wed May 08 11:20:24 EDT 2013 | amelby
Thanks for the info on the Hydra tubes that will be helpful. I found the answer from one of the Mydata techs. The Camera needs the hydra head to go slower then 1.9m/sec and the setting was at 1.8m/sec. They found out that even if the machine was set
Electronics Forum | Wed Jun 17 01:02:16 EDT 2015 | armandogomez
Hello Had a similar problem way back with the hydra, first go to the service program manually activate the hydra camera then move the Xwagon to place the hydra ref plate over the hydra camera and check first if the camera works, second the image you
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Sat May 04 11:24:08 EDT 2013 | amelby
Hi, I have been having a problem with my My19E's hydra. The machine comes up with an error "Failed to locate HYDRA tool reference marks" and stops running. It does not happen for about the first two hours of running. It starts to happen after that an
.png)
