Electronics Forum | Thu Mar 28 14:28:26 EDT 2024 | kingkelvin
We have MY9 - when it changes hydra tooltips - most of the time it makes a small "hitting" type noise - with error F-MOT MOVESLOWMOVE HYDRA Z/205 - however you can just hit continue and it will always change the tools and finish the board - I've un-i
Electronics Forum | Mon Apr 08 15:07:56 EDT 2024 | tey422
To me, it seems like there are slightly XY offset. Hydra might be able to pick up the tips, but not all the way securely attached to the hydra tubes. So, when the tips put back are not fully seated, which causing the tool stick inside the bank. You
Electronics Forum | Fri Jan 19 05:46:59 EST 2018 | ivammendes
MYDATA MY9E: Hydra's pipe can't stop the vacuum during assembly. The problem ocurre just in only one pipe, the number 5. The tool picks components but doesn't drop it. Can the problem be in the unit vacuum?
Electronics Forum | Thu Dec 15 11:28:45 EST 2016 | huske
Depends on the size of the elec cap and the nozzle set you have. But if you can pick it up, the wrinkle on the top of the cap can be a PIA. All you need to do is make sure the cap is being taken over the line-scan/hydra camera to center only (no mec
Electronics Forum | Thu Mar 28 17:13:11 EDT 2024 | tey422
It's been long time, me memories are fading away. If I remember correctly, you would need small flat surface plate or something to cover up the "linescan" hydra camera, so from the reflections value then it can calculates the actual height "lowest"
Electronics Forum | Wed Sep 21 12:12:24 EDT 2005 | vikkaraja
HI there, I have a problem with my TP11 HYDRA HEAD. It is not picking up parts from the magazine. I have been working with Mydata on this issue, but I have not had much success so far. So far I done the followings:ran vaccum test, tube height, and H
Electronics Forum | Tue Apr 02 18:25:00 EDT 2024 | kingkelvin
Yes very good - thank you, I'm getting the specific hydra tool offset jig from PFI Florida for $100 - and MyData has already quoted me all the other parts such as in that box there - so I'll get some of these in and continue my work. Thanks all!
Electronics Forum | Thu Mar 28 17:00:32 EDT 2024 | kingkelvin
For the hydra camera z-level - there is short section in manual - mentions using metal ruler to cover the camera - but for the other cal steps - I see nothing in the manuals for instructions - so I don't know if any special jigs are needed? I don't h
Electronics Forum | Thu Dec 15 12:45:15 EST 2016 | emeto
llllGodly, I did try before, but it wouldn't pick it - it will automatically select a tool for the single head. Do you think it has something to do with the fact that IO used ODD SHAPE recognition?
Electronics Forum | Thu Jan 05 12:33:30 EST 2017 | rgduval
If you haven't resolved this yet, I think you're going to want to go to either the part or the package (I'm not sure which one off hand), and make sure that the hydra heads/tools are selected for placement. You'll also want the vision set to the lin
