Used SMT Equipment | Flexible Mounters
144, 8mm feeder capacity, New 2000; 14,400 CPH; Equipped with Hydra with 8 heads Positioning Vision System; Equipped with Midas (Mechanical Centering System); Equipped with Optical Centering System for large fine pitch comp; 2.1.5 (software); 19206
Used SMT Equipment | Pick and Place/Feeders
Mydata MY19 Package - Will Sell Via Auction. Please see www.xlineassets.com for details. Mydata MY19 Pick and Place System With Magazines, Feeders, and TEX Tray Loader. Serial # 19162, Auto Conveyor System, Hydra and Midas Head, Two Pole Test O
Industry News | 2013-11-15 17:15:52.0
Productronica 2013: The new MY200 performance series features a new linescan vision system and a new high-speed mount head, delivering twice the accuracy and higher throughput.
Industry News | 2005-02-17 09:43:45.0
STOCKHOLM, Sweden, Feb 14, 2005
Industry News | 2013-04-12 08:14:52.0
Following on from recent investments to augment its test facilities, including a new flying probe tester and additional AOI facilities, the investment continues at JJS Electronics with orders recently placed for a complete new state-of- the-art surface mount line. The line is in response to increased demand for their PCB assembly services and will be fully operational in January.
Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser