Electronics Forum | Sat Nov 08 00:28:25 EST 2014 | padawanlinuxero
Hello We a Mydata and put all kinda of components with the midas unit, but never had problems with ESD, and some of them are very delicate parts, perhaps like our colleague said perhaps you should look at the trays or feeders that you are using, pe
Electronics Forum | Thu Sep 01 17:20:06 EDT 2005 | Mike
Is anyone currently mounting 0201's with the Hydra/Linescan combination with good results? We have a My series machine and are currently mounting the 0201's with high res camera. The results are good but it is painfully slow. Thanks in advance for
Electronics Forum | Wed Jul 11 14:19:04 EDT 2007 | fredericksr
We don't have a linescan. I wish we did. I can't afford to use the DVS for all the 0402s. Thanks!
Electronics Forum | Sat Sep 26 21:45:37 EDT 2009 | casmt
It didn't see the ref points on the bottom of the hydra head. start by checking the camera for dirt or dropped parts. Is it a hydra camera or Linescan?
Electronics Forum | Thu Jan 05 12:33:30 EST 2017 | rgduval
If you haven't resolved this yet, I think you're going to want to go to either the part or the package (I'm not sure which one off hand), and make sure that the hydra heads/tools are selected for placement. You'll also want the vision set to the lin
Electronics Forum | Wed Jul 18 14:55:30 EDT 2012 | mikesewell
We bought from Mydata and recently had a new Midas head put in by Mydata and I've been on the phone with tech support. This has been a intermittent issue that's been hard to pin down.
Electronics Forum | Thu Nov 15 23:45:53 EST 2012 | jaimebc
robgd3, The Z motor can be purchased separately, however, the theta motor can't. You need to buy the whole midas head. I didn't get as far as dissembling the theta motor casing to get to the theta motor. That was my worse case scenario. We ran thou
Electronics Forum | Mon May 09 19:00:47 EDT 2022 | SMTA-64387687
Z-force sensor is a tool travel indicator. It has nothing to do with Z travel. Does the Midas head move at all, during initiation? It sounds to me like a Z motor/encoder problem. Is the Midas head ribbon cable plugged in?
Electronics Forum | Fri Jan 05 16:16:51 EST 2024 | mistrthou
Based on the my15 we used to have and our current My100's I'd say it lost the position of the tool bank. Is it Hydra or Midas tooling? Uninstalling and reinstalling the hydra tool bank is fairly easy. If it's Midas tools, does it fetch other tools
Electronics Forum | Tue Aug 28 11:03:40 EDT 2012 | mikesewell
The problem is still intermittent. It has a new MIDAS head, installed and calibrated by Mydata, FWIW. Usually we work around it by moving parts upstream (Fuji AIM). I'll post an update when I finally chase the issue down.
