Electronics Forum | Tue Jul 17 12:57:41 EDT 2007 | cyber_wolf
Is your machine a TP9 2U ? If you have a UFP or a MY series machine this condition usually points towards a bad X-wagon motor.
Electronics Forum | Wed Jul 18 07:48:12 EDT 2007 | cyber_wolf
Bad small X motor most likely. Other possibilities: Bad cables Bad Card
Electronics Forum | Thu Jul 19 06:57:15 EDT 2007 | cyber_wolf
Peter, GO TEST YOUR SMALL X-MOTOR IN THE SERVICE PROGRAM !!!!!! Do not start changing parameter files ! I assume that your machine worked fine at one time with the original parameter file.
Electronics Forum | Mon Aug 06 18:58:12 EDT 2007 | edruppert
This message indicates that the Peak to Peak voltage for the x axis motor encoder is too low. Possible cable/encoder or MOT1 board problem. Machine will either exhibit this during intialization or while running. Diagnostics in service routine may he
Electronics Forum | Tue Jan 04 14:06:58 EST 2011 | cyber_wolf
First I would confirm that both of your X-motors and transducers are working through the service menu. After that start looking at the big power booster on the back of the machine.
Electronics Forum | Tue Jan 04 15:11:57 EST 2011 | ev
The Xmotor tests just confirms that the hardware did not initialize.....unless I am looking at the wrong menu. I have external fans on the booster board and the X motor on the back of the machine as well as one blowing directly into the computer box
Electronics Forum | Thu May 09 15:33:01 EDT 2013 | shankar2013
No luck yet. Also cannot buy a Cent electrode motor from manufacturer. Anybody know of sources where we can buy spares for TP-9. Thanks
Electronics Forum | Fri Sep 05 09:42:41 EDT 2014 | cflames17
If you call service they can also walk you through the motor test. Ask for Glen. Al no longer works for MYDATA.
Electronics Forum | Fri Sep 18 10:58:04 EDT 2015 | adventurelights
Thanks, have checked the vacuum tube and ribbon cables. They seem to look ok. Theta motor seems to be woking. I'm leaning towards the theta encoder going wanky. Is that possible?
Electronics Forum | Thu Oct 01 15:25:09 EDT 2015 | adventurelights
Which encoder did you replace? The one sitting on top of the midas shaft and below the small board or the one attached t the motor next to it? I don't even know if the first one is an encoder.