Electronics Forum | Thu Nov 15 19:56:18 EST 2012 | rgduval
I would have said it sounded like a motor/encoder problem...but, since you found the broken resistor, that was likely the source of your issue. The resistor and capacitor are a filter for the motor, MyData likes to put them on nearly all of the moto
Electronics Forum | Fri Jun 03 14:21:48 EDT 2011 | rgduval
I haven't seen that particular fail....but... What was the failure with the M controller? Might try moving your MOT cards around, to see if the failure follows one particular card. If so, you'll know you need a new MOT card. That might satisfy th
Electronics Forum | Fri Jun 03 15:19:19 EDT 2011 | jeremymc
After reseating the M controller boards I was able to get further than I had previously, no save status error, and was given an error about the voltage being wrong. During my last run my company had an electrician in to rewire somethings and put a
Electronics Forum | Thu Oct 18 16:09:34 EDT 2018 | emeto
Interesting. What changes in 1 hour? Is there any connection between the error and feeder/magazine change, load reload? Is there any other factor observed in the hour of work that is abnormal?
Electronics Forum | Fri Oct 19 08:35:52 EDT 2018 | stephendo
IIRC There is a friction test? If I remember correctly, what is the result?
Electronics Forum | Tue Oct 23 11:19:46 EDT 2018 | tech1
This wound up being a power supply cutting out after a period of operation.
Electronics Forum | Thu Oct 25 01:13:55 EDT 2018 | mk15
thank you for your advice, the problem was in the elmo source 350V, there was a problem of dropping voltage when the engine accelerated.
Electronics Forum | Fri Sep 05 09:22:53 EDT 2014 | rgduval
Hi, Rebecca, Hmm...two x motors? I'm a couple of years removed from MyData's, but, I don't remember two x-motors. Might be something in the My12's that I didn't see in my older My9 (and certainly not in my TP9). As to the small board...unfortun
Electronics Forum | Mon Jul 16 10:45:47 EDT 2012 | cyber_wolf
The trandsducer on the motor.
Electronics Forum | Fri Jun 03 11:13:28 EDT 2011 | jeremymc
I've been running a MYDATA TP11 for over a year now and yesterday when I turned it on I was given an error that I have never seen before. It had been a week since the last time I had used the machine and when it was turned on it told me that there
.gif)
winsouce.jpg)
