Where High Mix Meets High Speed. With the MY100e series pick-and-place machines, there’s no need to make the usual trade-offs between speed and flexibility. With the fastest changeovers in the industry and workcell solutions reaching speeds of up t
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Thu Mar 28 15:18:21 EDT 2024 | tey422
From the error message, might have to do with the "Z"-axis. You didn't mention you redo the calibration or not, then you should run that too. My guess would be "Z reading maybe slightly off". BTW, last time I work with those Mydata machine were bac
Electronics Forum | Tue Mar 31 15:14:53 EDT 2009 | kpm135
Is your machine an inline system with the conveyors along the back? If so I have run into this problem before with the sensors on the covers for the conveyors. They are 'magnetic' safety switches that can appear to be closed but don't actually switch
Electronics Forum | Fri Apr 26 08:38:14 EDT 2002 | ian
We have had Mydata for eight years and Siplace for six. We have found that the Siemens is much more accurate and faster than the Mydata (about four times quicker). Although the Mydata is more friendly regarding the software, if the upfront preparator
Electronics Forum | Wed Nov 09 07:31:41 EST 2005 | smtspecialist
The part I'm having problem with is a simple 0805 resistor 0R the inspection is done optical not mechanical and 75% of the rejects rate has the message: one or too many bad leads found. and the other 25% the messages will give a Background or Contras
| Sm | t | net |
| 1 |
