Electronics Forum | Tue Nov 20 15:03:37 EST 2012 | jaimebc
Bruce, Since we had spares, I replaced the X wagon cables, XFMB cable, nothing. FFX Cable, nothing. Swapped mot cards, nothing. Vaccum seal, nothing.At this point I truly believe the problem is either on the theta encoder or the theta motor. Unfortu
Electronics Forum | Fri May 24 11:34:08 EDT 2019 | jstebbs89
Running a Mydata 15E and in the middle of a board the machine will freeze. Restart the machine and try to initiate the hardware, get an error message of F-MOT-MSETDYN X/163: Illegal value of DSP command arguement I've check all the connections on t
Electronics Forum | Thu Mar 23 13:36:30 EDT 2023 | tomdegas
Running a Mydata MY 9 and trying to Restart the machine and try to initiate the hardware, get an error message of F-MOT-MSETDYN X/163: Illegal value of DSP command argument. It seems to be related to the x drive. I've check all the connections on
Electronics Forum | Fri Nov 22 10:24:28 EST 2019 | rgduval
When you swapped the MOT card, did the proble move to another axis? I'm guessing no, but, wanted to clarify. If the problem did not move, you either have an x-motor problem, x-motor counter problem, or x-transducer problem as noted. Or, a cable pr
Electronics Forum | Fri Mar 06 19:32:09 EST 2020 | SMTA-Alex
The fact, that your Hydra head goes up and then starts moving slowly, means that it didn't find the limit. Since there are no mechanical obstructions and you swapped all the boards, the things to look at are cabling. Double check the ribbon cables fo
Electronics Forum | Sun Nov 27 11:19:55 EST 2005 | cyber_wolf
Dude, Scope the big ribbon cables on either side of the X-axis for cracks. They usually break where the clamp holds them on the X wagon. Also, all of your X camera stuff goes through the XWB board.Try swapping it if you have another. I am not sure
Electronics Forum | Mon Apr 06 17:08:30 EDT 2020 | tima
Try swapping XWB board that is on top of X-Wagon. Have you try that? All signals go thru there. Another thing can be those 2 ribbon cables that are behind of X-Wagon. How long ago did you change them? What I would do is to move X to different positio
Electronics Forum | Wed Jul 18 07:48:12 EDT 2007 | cyber_wolf
Bad small X motor most likely. Other possibilities: Bad cables Bad Card
Electronics Forum | Mon Aug 06 18:58:12 EDT 2007 | edruppert
This message indicates that the Peak to Peak voltage for the x axis motor encoder is too low. Possible cable/encoder or MOT1 board problem. Machine will either exhibit this during intialization or while running. Diagnostics in service routine may he
Electronics Forum | Thu Jan 06 13:56:46 EST 2011 | ev
Thanks for this detail. The X wagon responds as per the instructions here so I'll give the cables a good inspection.
winsouce.jpg)
