Electronics Forum | Fri Jun 27 13:33:59 EDT 2014 | rgduval
I agree with all other posters...strips on the Y-Wagon have always worked out, rather easily. Some people I've met consider it a benefit to having a MyData. However, I would add that MyData's handle strips in the feeders better than most other pick
Electronics Forum | Tue Oct 27 11:20:16 EDT 2009 | smtspecialist
I had the same problem back in March with my MY12, since I have two identical lines i swapped things around until swapping the x-wagon motor (the one for fine movements). When I swapped the x-motor I move the problem from one line to the other gener
Electronics Forum | Thu Jul 23 09:15:18 EDT 2015 | padawanlinuxero
mmmmm.... what type of y wagon you have on the mydata?
Electronics Forum | Tue Apr 09 21:57:42 EDT 2019 | alexvolovich
If you were able to do a first/last part, then your tray wagon is set-up. You need to go to Tray Types and program the tray that will match the piece of tape you have. Then you should be able to add your component to the tray wagon.
Electronics Forum | Tue Sep 08 09:37:55 EDT 2009 | cyber_wolf
We are seeing intermittent X-transducer errors. I notice that the X-wagon has more resistance over the Y-wagon area when I manually push it back and fourth. I am thinking the belt might need replaced. Has anyone else seen this before.
Electronics Forum | Tue Jun 24 14:00:58 EDT 2014 | joekirin
We built a tray that accepts tape. It is made out of a waffle tray and board breakaways. It works very well. We use magnets to mount it on our Y-Wagon teaching it as a tray.
Electronics Forum | Thu Jul 20 10:48:43 EDT 2006 | pms
Ev, This error could be caused by any number of problems. Is there an error message in the message window before hardware initiation error? If so, what is it? A failure in any axis (x,y,z,c,theta,y-wagon,tray-wagon) could cause your symptom. Paul
Electronics Forum | Fri Apr 15 08:23:14 EDT 2005 | cyber_wolf
We are seeing more and more jobs come in with matrix tray parts for our mydata machines. The problem is that the largest Y wagon will only hold 3 or less trays. We have some jobs that have 10+ trays. Currently our operators cut the trays down to sma
Electronics Forum | Tue Nov 15 16:57:22 EST 2005 | bk
If your problem is happening part way through the calibration the problem might be there is too much friction from your Y-wagon. Measure the friction on the Y-wagon using the service program if it fails or if it is near the max allowed try oiling up
Electronics Forum | Thu Jun 26 06:14:16 EDT 2014 | allgood
We find sticking tape down to the tray wagon or to a base plate is Ok but not very repeatable - when you peel the empty off and stiock a new on e down you have to relocate it every time so some way of holding the strip in a repeatable way is better.
