Electronics Forum | Thu Jul 23 03:15:43 EDT 2015 | padawanlinuxero
So let me get this straight you want the mydata to pick the SOT-23 from the reel tape take it to a part of the y-wagon put the SOT-23 inside the programmer, program the sot-23 have the midas (which is the only one can do something similar) pick up th
Electronics Forum | Thu Mar 17 06:56:41 EST 2005 | Grant
Hi, Even if you don't use vision or a HYDRA head, the MYDATA should still sense no component, and try 3 times by default. Also, if the MYDATA does not place the component it will not be marked as places, so the placement program won't ever finish. Y
Electronics Forum | Tue Sep 22 16:39:10 EDT 2009 | rmitchell
Hi, We are getting a E-Hydra-1 Frame grabbing failed on caps and resistors and also a Light Curtain trigger X wagon. I spoke with mydata and they indicated the light curtain might be getting set off and causing the frame grabbing failure. I cleane
Electronics Forum | Fri Mar 24 16:45:03 EDT 2023 | tey422
I believe I was working with the early MY12 model too. Yes, the X-wagon blue ribbon cable were showing wear and tear very fast. Another frequent break downs were the center-jaw, ribbon broke. Most of the Mydata repairs can be done inhouse with spar
Electronics Forum | Fri Feb 11 16:11:52 EST 2005 | Grant
Hi, Your right, and that's the thing I liked about MYDATA, even though we are selling ours now, and putting in Fuji'. I would still by a MYDATA if I was starting again, and doing low volume. When we started we kept our first product as simple as po
Electronics Forum | Sun Nov 10 14:17:40 EST 2002 | anonname457
We just went through the same comparison shopping for our company -- and we ended up choosing Juki machines -- as our comparison was between a MY9 with a hydra head and the Juki 2010 & 2020 combo. Both machines have excellent software packages and ar
Electronics Forum | Mon May 06 19:21:39 EDT 2013 | amelby
We had that problem on our M12. There were a few > components that had gotten dropped into the > camera area as the hydra head past over it. Our > MY12 has a knob towards the front of the machine > in direct line with the camera. Pulling this
Electronics Forum | Thu Sep 04 16:36:29 EDT 2014 | chemers
Thanks for the response, Rob. I tried the MOT cards and the problem did not move. I swapped the MOTY with the MOTX, but the MOTX had a small board attached to it that I moved to the MOTY that I tried. Do you know if there is a way to test that small
Electronics Forum | Fri Sep 05 09:33:32 EDT 2014 | cflames17
It could very well be the Safety Relay located inside the ELMO PSU (Bottom left in computer cabinet). I just had the same problems on 2 MY9's within 2 months apart. the Part cost around $700.00 from Mydata (Now Mycronic). These fail commonly with old
Electronics Forum | Wed May 09 17:49:16 EDT 2012 | dyoungquist
We run a Mydata high mix, low volume line. You can handle strips with either the Agilis feeders (losing the first 5-10 parts) or by placing the strip on the Y or tray wagons. For cheap parts like resistors, capacitors, some diodes and small ICs, ou
