Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o
Electronics Forum | Fri Sep 05 09:22:53 EDT 2014 | rgduval
Hi, Rebecca, Hmm...two x motors? I'm a couple of years removed from MyData's, but, I don't remember two x-motors. Might be something in the My12's that I didn't see in my older My9 (and certainly not in my TP9). As to the small board...unfortun
Electronics Forum | Mon Oct 22 08:27:49 EDT 2018 | filipblad
Hi, We're having issues with our mydata tp9 pick'n place. It doesn't go all the way down on the tool, so it can't pick it up or install it. The fault code I get when trying to install tools is F-TLMN-18: Can't reach tool bank. Any ideas? I've comp
Electronics Forum | Fri Mar 20 18:04:59 EDT 2009 | clearblue
We are having the same error message (F-Axis-23: X-Axis transducer ch.1 PTP value too low) on our TP9-2U that you had in 2007 with your TP9 2. I am hoping your memory is excellent, you are still at this email address, and you were able to fix the ma
Electronics Forum | Tue Jul 22 09:12:58 EDT 2008 | chiptargets
Hi, I posted a similar message yesterday, but I believe it did not make it through properly. I apologize. We have an error while trying to perform Initiate Hardware test. The error was "F-MOT1-25/205:MOVZ: Motorspeed Out of Control". The error, ho
Electronics Forum | Mon Sep 21 00:11:14 EDT 2009 | darrenj
We have a TP9 with a centering motor issue. (TPSYS Ver 2.5.3) The error message F-MOT-SETDYN C/3 Upper endpoint outside limits is shown during C-motor initiation. I've looked in the service program and also the parameters in TPSYS but can find no m
Electronics Forum | Tue Feb 28 12:29:20 EST 2012 | richieoreilly
Hi All, I am currently looking at purchasing an SMT machine with 01005 and flip chip capability, We have a limited budget but have found some machine which may suit. Mydata MY100LX10e Fuji NXT, 2nd hand 2007 vintage, Yamaha YS12F Do any of you ha
Electronics Forum | Wed Jun 27 12:51:53 EDT 2012 | cyber_wolf
You can leave the booster in the original position and mount two small fans directly underneanth it blowing upward. By leaving it in the original upright position you get quite a bit of air velocity in the small space between the booster and the mach
Electronics Forum | Thu Oct 15 10:21:30 EDT 2015 | azdback
troubleshooting a table lift error on MY12. Error code: F-MOT_Releaseboard conveyor lift/1304. Basically, the table got stuck on the up position. Also bench tested both lift motors and they are ok.Rotated the lift motors manually to test the encoder
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
winsouce.jpg)