Electronics Forum | Fri Jul 10 15:30:56 EDT 2015 | tamazula
good afternoon we have a M12 MYDATA gives us an error code (f-mot-move x / 143. position out of bounds, lower end) and can not initialize the hardware. If you can help please .... thank you ...
Electronics Forum | Thu Oct 18 16:09:34 EDT 2018 | emeto
Interesting. What changes in 1 hour? Is there any connection between the error and feeder/magazine change, load reload? Is there any other factor observed in the hour of work that is abnormal?
Electronics Forum | Fri Oct 19 08:35:52 EDT 2018 | stephendo
IIRC There is a friction test? If I remember correctly, what is the result?
Electronics Forum | Tue Oct 23 11:19:46 EDT 2018 | tech1
This wound up being a power supply cutting out after a period of operation.
Electronics Forum | Thu Oct 25 01:13:55 EDT 2018 | mk15
thank you for your advice, the problem was in the elmo source 350V, there was a problem of dropping voltage when the engine accelerated.
Electronics Forum | Mon Nov 25 02:15:07 EST 2019 | mk15
it is possible to test x belt motor and x wagon motor.
Electronics Forum | Fri Oct 12 11:21:43 EDT 2018 | tech1
There are 2-X motors and numerous items that could be causing this: 1 of the X motors, 1 of the X transducers, 1 of the couplings connecting the motor and transducer, X Kevlar Belt. If you know how to go into the service portion of the software you
Electronics Forum | Sat May 29 14:03:18 EDT 2010 | padawanlinuxero
Hello guys! I have a problem I had to change the MI Board on a MYDATA TP9-4 machine because it was firing 3 or more feeders at the same time, after the change it run great but then for some reason after a while it start to show an error message that
Electronics Forum | Tue Nov 13 11:14:15 EST 2012 | jaimebc
For the past few weeks we have experienced an intermitent midas theta error.During normal production the machine times out while just after picking up a component waiting for the theta to center it.Sometimes it fails to leave a tool. Reinitianing the
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
.gif)
