Electronics Forum | Mon Apr 29 09:58:38 EDT 2002 | pjc
Machine Data Mydata MY9 machine weight: 1800kg placement repeatablilty @ 3 sig: 15 micron x-y axis drive mech: x combo belt rackπnion, y ball screw Siemens F5 machine weight: 1500kg placement accuracy @ 3 sig: 30 micron x-y axis drive mech: x belt
Electronics Forum | Fri Aug 06 14:01:53 EDT 2021 | tomdegas
Unfortunately all my tools are spring loaded. Yes I do know the tool install utility. I have been running and maintaining the 3 MyData machines for over 20 years and I never saw an error like this. I grease our tools once a month so I know that is
Electronics Forum | Thu Jul 20 11:18:43 EDT 2006 | ev
Paul, the error says "MOT1-38-247 MSETDYNX: Xwagon fan not working." I have checked...the X motor fan and it is working...the fan behind the PAIB board is also working...I checked this because there is a connector marked X wagon fan on the PAIB boa
Electronics Forum | Tue Oct 27 11:20:16 EDT 2009 | smtspecialist
I had the same problem back in March with my MY12, since I have two identical lines i swapped things around until swapping the x-wagon motor (the one for fine movements). When I swapped the x-motor I move the problem from one line to the other gener
Electronics Forum | Fri Mar 24 16:45:03 EDT 2023 | tey422
I believe I was working with the early MY12 model too. Yes, the X-wagon blue ribbon cable were showing wear and tear very fast. Another frequent break downs were the center-jaw, ribbon broke. Most of the Mydata repairs can be done inhouse with spar
Electronics Forum | Thu Sep 04 16:36:29 EDT 2014 | chemers
Thanks for the response, Rob. I tried the MOT cards and the problem did not move. I swapped the MOTY with the MOTX, but the MOTX had a small board attached to it that I moved to the MOTY that I tried. Do you know if there is a way to test that small
Electronics Forum | Wed Apr 26 14:06:46 EDT 2006 | mdm4ua
Hi JEM, We just made the very same upgrade you are looking to make on three machines. We purchased a new MY12 and upgraded our other three (My9 W/hydra, My9 No Hydra, and TP9-2U) from 2.2.4C to 2.4.4c. There are several changes and most of the
Electronics Forum | Tue Apr 05 11:03:13 EDT 2005 | cyber_wolf
There are several things that can cause these errors. It sounds as if you have 2 problems. A (Z) problem and a theta problem. 1. Check that the Z-locks are functioning properly in the service program. Make sure that when they are un-locked they don'
Electronics Forum | Fri Sep 02 07:38:13 EDT 2005 | DannyJ
Hi Mike, I haven't tried the 0201s with a Hyrda, but after seeing 20 reviews of your message without a response, I'll try and share my experience with 0402s on a non-Hydra machine. The 0402s are slow, but I managed to get some speed by maxing out
Electronics Forum | Tue Jul 10 11:36:22 EDT 2007 | dyoungquist
Hi SMT Frog We are using an upgraded Mydata TP9-1 system to place 0402s. We do an electrical test plus mechanical centering and use the C14 tool. A few things we have observed/learned: 1) Is the machine not picking the part up out of the tape? Po
