Electronics Forum | Mon Mar 06 10:54:22 EST 2006 | fredericksr
We have also had some of the same problems, but at the risk of sounding redundant, we have had success in using both the 8mm and 16mm tape clips to secure the tape. We have also been very pleased with the adjustable 16mm feeder doing a job the regul
Electronics Forum | Fri Oct 21 12:19:36 EDT 2005 | ratsalad
I can see this being useful to a company that needs the ability to do one-day turns on prototypes. The type of situation where your customer shows up at your door with two bags, one is a bag of parts and the other is a bag of cash and they say they
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
Electronics Forum | Fri Jul 20 05:09:42 EDT 2007 | allgood
Yes that sounds worth a look - thanks. I am also wondering if there is a thermal issue - we had 27 degrees in here yesterday and I remember the Mydata guy telling me to put a desk fan onto the card frame in the summer. I did this last year - when I
Electronics Forum | Mon Nov 10 09:11:51 EST 2014 | rgduval
The centering jaws are made out of copper, I believe...and conductive. I'd suggest that the conductivity of the copper makes it a fairly poor source of ESD damage in a component. I have observed physical damage to components from the centering jaws
Electronics Forum | Mon Aug 05 15:26:09 EDT 2002 | John Patricelli
I've attended the Advanced Programming Course and the Maintenance Course at their Rowley, MA site. I also talked to the trainer, Toby Upham, about some of the other training courses they provide. It sounds like the New User Training course covers m
Electronics Forum | Wed Nov 09 05:44:06 EST 2005 | grantp
Hi, It sounds like your vision is not setup right for this component, and it's rejecting some of them because they would be failing the test. This brings up a point we discovered. Don't use auto teach for the component if your using HYDRA or vision
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Sat Dec 18 18:29:16 EST 1999 | M Cox
Clarissa Even with a sound support team, buying used equipment is always risky. Some things to consider 1) Call the manufacturer, and make sure they still support the equipment, Parts and Technical. 2) Look at the machines with somebody who knows t
Electronics Forum | Tue Apr 05 11:03:13 EDT 2005 | cyber_wolf
There are several things that can cause these errors. It sounds as if you have 2 problems. A (Z) problem and a theta problem. 1. Check that the Z-locks are functioning properly in the service program. Make sure that when they are un-locked they don'
.png)
.jpg)