Electronics Forum | Thu Feb 06 12:32:24 EST 2014 | gnus
Hi all, During our last production run, our MyData TP9 machine shut down on its own mid assembly. Screen went blank. I turned off the power switch and waited 10mins before trying to power it up again. I turn the switch on and hear the fan turning on
Electronics Forum | Tue Jun 19 17:42:38 EDT 2007 | dyoungquist
We run a TP9 machine and had a very similar problem with it. On a TP9 machine there is a power supply board where all the voltages are generated. It is located on the bottom side of the unit. The problen was with one of the fuse holders. The co
Electronics Forum | Thu Oct 16 12:35:03 EDT 2014 | upguy
We have tpsys 1.5.18 on our TP9-UFP. We are attempting to run "Optical Centering Calibration". Following the instructions in the manual, we have centered the cross hairs on the camera frame, loaded a "base" board then the L-19-447 calibration boar
Electronics Forum | Tue Aug 22 17:03:32 EDT 2006 | pms
Steve, Be careful with that TP-9.......... Mydata will support the machine (as long as you pay a registration fee, I believe), but no support for real old software versions. Make SURE it has at least software version 1.6 or above. If not, the magaz
Electronics Forum | Tue Oct 30 12:03:32 EDT 2018 | cambriadj
It is always an enticing thing to watch high speed machines planting parts lickity split. We are a small shop doing experimental and short runs, and have been running our dear old Mydata TP9-2U for years. No repairs, never failed because we have alwa
Electronics Forum | Tue Sep 23 13:05:03 EDT 2003 | Pete
Mydata sells refurbished machines FYI. TP9 w/ 64 8mm can be less than $45K.
Electronics Forum | Tue Nov 15 08:17:05 EST 2005 | cyber_wolf
What are you trying to calibrate? I think you mis-typed...there is no W-wagon. I think you meant X-wagon camera. I have never seen one of these go out of cal. Why do you think it needs calibrated ?
Electronics Forum | Tue Feb 20 20:07:33 EST 2007 | mdang
My machine TP9-2U have the same problem. I use the camera to walk through the program and it is off and not repeatable. I think the machine has backlash but I don't know how to tighten it up. Can you help??? Thanks, -Michael
Electronics Forum | Tue Feb 27 21:20:23 EST 2007 | mdang
This is the TP9-2U machine and have about 2000 hours on it. When I used the camera to walk through the program, it is not repeatable.
Electronics Forum | Tue Jul 17 12:57:41 EDT 2007 | cyber_wolf
Is your machine a TP9 2U ? If you have a UFP or a MY series machine this condition usually points towards a bad X-wagon motor.
