Electronics Forum | Fri Jun 30 11:33:04 EDT 2000 | Walter
CAL Comp 34180 DIGITIZER Installation on MYDATA TP-11UFP Installed per set-up & installstion documents provided by CAL Comp. When trying to activate mouse get no result.
Electronics Forum | Thu Mar 24 10:15:56 EST 2005 | blueflag
Dear All We are using a my12 also tp11 with VIB feeders we are having major problems with ics in tubes are there any machines available to convert ics up to so16 from stick to tape & reel and are the cost effective ?????? Thanks Colin
Electronics Forum | Tue Apr 05 05:19:30 EDT 2005 | blueflag
Breakdown help machine will not 0 set upper end point limits on Z axis Theta / lower end point missed Thanks Colin
Electronics Forum | Tue Apr 05 12:45:01 EDT 2005 | cyber_wolf
Make sure your matrix tray is up high enough. The components in the matrix tray should be at least at board level. Also check your component height in the package list. If all that is OK then, check those Z locks I spoke of earlier.
Electronics Forum | Thu Apr 07 08:57:06 EDT 2005 | blueflag
have been through somethings with an engineer on the help desk and the concusion is that it is the z motor with the encoder that is causing the fuse to go so have ordered another. Not cheap though at nearly �500. Thanks very much for your help, it
Electronics Forum | Thu Sep 29 07:51:09 EDT 2005 | chris
Have it been working earlier. Have you try to run it in stepper mode (ctrl s to start and ctrl e to exit)and look at the messages? That can be a good thing so you can analys if it goes down correctly or not.
Electronics Forum | Fri Oct 07 07:31:37 EDT 2005 | cyber_wolf
We use a program called ghost. It works. http://www.newegg.com/Product/Product.asp?Item=N82E16832108190
Electronics Forum | Thu Jul 20 11:43:15 EDT 2006 | pms
Ev, That's a new one for me. Sorry, can't be of help on that problem. Good luck and keep us informed. Paul M.
Electronics Forum | Wed Jul 26 15:28:11 EDT 2006 | RLM
How does the machine sense that the fan is working/not working? The fan may be operational but the sense mechanism may be at fault.
Electronics Forum | Fri Jul 11 08:24:58 EDT 2008 | ev
We are a small prototype small volume shop looking at getting more work that involves placing BGA's. What are the concerns or issues that we should be focusing on. We have an ABW 10 zone oven and a Mydata TP11-UFP with a SMT techniques stencil printe