Electronics Forum | Wed Oct 23 15:22:11 EDT 2019 | bk
There should be some other error message also with the hardware initiation error. This will help us narrow down your problem
Electronics Forum | Fri Oct 29 17:48:46 EDT 2021 | artem
Hello, I have found the problem. The capacitors on the PAIB board were leaking. They have even demaged some traces and vias on the PCB and the -5V supply on the PAIB board was not working anymore. Got it working again :)
Electronics Forum | Sat Nov 20 04:32:45 EST 2021 | smtusa
Will TM series feeders (from a TP-11) run slow on a MY series machines with HYDRA head? Are there any MY series machines with dual HYDRA heads?
Electronics Forum | Tue Nov 23 02:23:27 EST 2021 | SMTA-64387687
The TM magazines will work exactly the same on the newer machines, as they did on your TP-11. The MY100, MY200, and MY300 series machines are all available with 2 heads, Midas and Hydra.
Electronics Forum | Thu Apr 07 07:17:54 EDT 2005 | cyber_wolf
Colin, At this point you may consider calling in Mydata. I told you the basic things I have seen cause your problems. It sounds as if you may have a bad card, and or short somewhere. Possibilities: XWB Small booster on the front of the computer bo
Electronics Forum | Tue Jun 19 11:28:10 EDT 2007 | kpm135
I am fairly new to the MYData machine. The TP11 we have just started generating the following error: W-MIPR-20:System voltage BATTERY measured 14.59V (outside limits). After talking with the operators and reading the manual I believe the problem may
Electronics Forum | Mon Aug 17 11:35:57 EDT 2020 | artem
Hello, I have some troubles with my MyData TP11-UFP with the precision of the placement. All the parts which are mechanically centered are slightly misaligned. Attached are some pictures of 0603 and a SOT23 part. I have made the calibration but it
Electronics Forum | Fri Dec 28 13:11:13 EST 2001 | cyber_wolf
Chris, I have worked with all kinds of Mydata's TP9,TP11,MY series machine for years. I have ran them, programmed them,and had just about every nut, bolt,motor, and circuit board out of them at one time or another.I have also written specialized mai
Electronics Forum | Wed Apr 06 09:16:31 EDT 2005 | blueflag
Ive just checked all the cables that i can see and there seems to be nothing wrong. Have just put a brand new fuse in to mot z card and it has blown it. machine boots up, initiate the hardware and everything goes ok until it does the z height then i
Electronics Forum | Tue Nov 15 06:46:41 EST 2005 | cyber_wolf
We have an earlier version of TPSYS. 2.4.1c We see this happen occasionally as well. It only seems to happen on our MY-12 machine. Our TP-11's never do it to my knowledge. I highly doubt that it is isolated to your company. If your machines are new,