Electronics Forum | Tue Oct 22 21:24:02 EDT 2019 | richgreen01
Hi All I have the above machine and every day on start up i get the failed to initiate hardware message.I have been getting around this by re initiating the motor controllers and it is good to go after this.Does anyone know the causes of the initiat
Electronics Forum | Thu Mar 19 21:06:19 EDT 2020 | sarason
In circumstances like these immediately switch off and remove your power supply , I often build a test harness because the damage to an expensive and unique machine is not woth the trouble of shotgun repair. Dead resistors in the voltage sense rail.
Electronics Forum | Mon Oct 12 17:25:09 EDT 2020 | rgduval
Release the e-stops :) Chances are pretty good that one or more of the e-stop switches is going bad. Pop them off, and measure with an ohm-meter to figure out which one it is, and replace. I don't recall anything in the software that identified wh
Electronics Forum | Mon Oct 25 11:20:52 EDT 2021 | bk
The 245 error is with your x belt motor not the x wagon motor. double check all the fuses on the back of the machine where your power comes in there should be 3 of them. if you haven't changed your blue cables in a while I would change those out. you
Electronics Forum | Fri Oct 07 12:13:39 EDT 2005 | jbrower
My experience with MYDATA has been good. Tech support has always answered my questions promptly and steered me in the right direction when I was at an impass. All in all the tech support department is great. Just my opinion and experiences. My curr
Electronics Forum | Fri Oct 07 16:29:52 EDT 2005 | bk
In 5+ years that I have been dealing with Mydata tech support, I never had any bad experiences. Their techs are very knowledgable of the machines. They are always courteous and patient,and if the problem cannot be fixed over the phone they always get
Electronics Forum | Fri Jul 08 08:07:20 EDT 2005 | bandjwet
Wen Pls send me the info on the MYDATA offline Bob
Electronics Forum | Mon Aug 09 15:30:55 EDT 1999 | Dewey
Greetings, Would like to buy a 3 phase UPS for our Mydata TP11. Been looking and generally, sales person's point of view, 10KVA @ $10,000.00 is what they recommend. Seems a lot to me??? Called Mydata and suggested 2.2KVA per phase. I would purchase
Electronics Forum | Tue Aug 17 11:03:36 EDT 2004 | Bernard Mulcahy
Hi , I am having an issue with my Mydata TP11 UFP. About 2 yrs ago I upgraded from TPSYS 1.6 to TPSYS 2.2.4 to enable me to use the agilis feeders. This involved an operating system change from Venix (Unix Clone) to a version of Linux. the upgrade i
Electronics Forum | Thu Mar 26 08:51:40 EDT 2009 | avalancher
Hi Sr. First suggestion is to call Mydata's phone support. With that said... Here is some ideas of what you could check: 1. Do you have power at the XWB board connector going to the motor (xxwm connector)? 2. Do you have power coming through the bl
winsouce.jpg)