Electronics Forum | Wed Mar 16 00:10:46 EDT 2022 | SMTA-64387687
Yes, your TM magazines will work. However, you will lose some performance.
Electronics Forum | Tue Jun 19 11:28:10 EDT 2007 | kpm135
I am fairly new to the MYData machine. The TP11 we have just started generating the following error: W-MIPR-20:System voltage BATTERY measured 14.59V (outside limits). After talking with the operators and reading the manual I believe the problem may
Electronics Forum | Wed Sep 30 06:25:14 EDT 2015 | strongbyte
I am looking to buy a Flexible magazine for a Mydata TP9-UFP I have seen both TMCFlex and TMDFlex magazines available, does anybody know the difference between the two and whether they are compatible with my machine. I spoke to a Mycronic engineer
Electronics Forum | Mon Mar 07 09:44:49 EST 2005 | anonomous
The machine sees a magazine, but with wrong number. somehow one (maybe more) wire from the magazine bus does not reach slot 3, as the other slots work, there is probably not a short, as the magazine bus work for other slots, the problem is probably i
Electronics Forum | Mon Mar 07 11:19:13 EST 2005 | cyber_wolf
Another thing : Make sure that there are no other mags plugged into the machine while you are trying to trouble shoot slot 3. I have seen shorted vibratory ID chips mess up other magazines up in different slots. For instance : a shorted vibe in slo
Electronics Forum | Thu Jul 18 17:38:27 EDT 2019 | rgduval
Not swapping out feeders....swapping out magazines. It only works well if you have enough extra mags to load all the feeders on. And is a viable solution if your position limited on your machine. Before the advent of Aegis feeders for My machine
Electronics Forum | Fri Apr 01 01:26:17 EST 2005 | Marv
A couple of things.. 1) The problem is more than likely on the magazine board itself (TC2), most likely the pal chip that stores the serial number and feeder information (you could swap this with a working magazine to verify) 2) The magazine connecto
Electronics Forum | Thu Jun 15 06:40:12 EDT 2006 | CL
Good Morning Paul, We are using the linear magazines as well as the old style and are processing 0402 and 0201's. I do have to say that the Agilis magazines work much better for smaller parts. Just make sure that you have the correct size clip for t
Electronics Forum | Mon Nov 09 22:33:42 EST 1998 | Jim McCarten
I have had experience with both companies. If you are doing contract work and get you parts and boards in a box, the Mydata does a fine job of teaching a board on the machine. Quad's strengths are in their software and the ability to automatically
Electronics Forum | Tue Jun 19 12:57:35 EDT 2007 | rgduval
I don't recall seeing a battery anywhere on the boards on the magazines. I'd give MyData a call, and ask them about it. They're pretty good on the phone. Might be the battery used for electrical verification . Good luck!
