Electronics Forum | Tue Apr 05 11:03:13 EDT 2005 | cyber_wolf
There are several things that can cause these errors. It sounds as if you have 2 problems. A (Z) problem and a theta problem. 1. Check that the Z-locks are functioning properly in the service program. Make sure that when they are un-locked they don'
Electronics Forum | Thu Jun 14 00:10:18 EDT 2012 | tech1
Most of it depends upon the type of Y wagon you have. if they are internal conveyors you need to remove the covers from the operator side. There are 3 screws holding the Y wagon down, 2 of them are hex screws and the one in front is an allen head. W
Electronics Forum | Mon Jun 28 17:17:23 EDT 2021 | SMTA-64387687
The 2 big ribbon cables, on top of the X wagon. They run from the booster board, in the back, to the board on top of the X-wagon. They wear out and need to be replaced, periodically. Since, the tool cycle works, the Z-motion is probably working ok. I
Electronics Forum | Tue Jun 14 15:59:25 EDT 2022 | mikevb
Thanks! I just needed a response like that. I will do all that, and if it's still an issue, I'll change the x wagon encoder right? There are three encoders on the x wagon though? The white one on the x carriage, the white one on the x belt drive mo
Electronics Forum | Wed Jan 05 10:55:12 EST 2005 | OverTheHill
WOW Sr.Tech, 40K worth of bent tools? I'm about ready to be sh*t canned because of 1K's worth. As for trimming the mags, the product is running fine (many boards) and then out of nowhere the tool bends, so I assume my PERFECT operators trimmed the ma
Electronics Forum | Tue Sep 08 09:37:55 EDT 2009 | cyber_wolf
We are seeing intermittent X-transducer errors. I notice that the X-wagon has more resistance over the Y-wagon area when I manually push it back and fourth. I am thinking the belt might need replaced. Has anyone else seen this before.
Electronics Forum | Wed Apr 06 07:59:17 EDT 2005 | cyber_wolf
Did you check the ribbon cables on either side of the X axis for cracks ?
Electronics Forum | Tue Jun 24 11:58:55 EDT 2014 | markhoch
We had both a MY15 and a TP11 both with tray wagons and we taped strips to the tray wagon all the time with great success. we used double sided tape, sometimes with magnets, and then created "trays" as if the tape strip was a matrix tray. (1 x 10,15
Electronics Forum | Wed Apr 05 10:53:52 EDT 2017 | prdmm1
we have the x wagon one and the one at the far right only.
Electronics Forum | Tue Nov 15 08:17:05 EST 2005 | cyber_wolf
What are you trying to calibrate? I think you mis-typed...there is no W-wagon. I think you meant X-wagon camera. I have never seen one of these go out of cal. Why do you think it needs calibrated ?
