Electronics Forum | Wed Jun 15 19:46:15 EDT 2022 | mikevb
Hey All. I figured it out. It turns out that the problem was simply a loose coupler on the x wagon motor transducer. I had only checked one screw in the past but the other screw was apparently loose as well.
Electronics Forum | Fri May 24 11:34:08 EDT 2019 | jstebbs89
Running a Mydata 15E and in the middle of a board the machine will freeze. Restart the machine and try to initiate the hardware, get an error message of F-MOT-MSETDYN X/163: Illegal value of DSP command arguement I've check all the connections on t
Electronics Forum | Thu Mar 23 13:36:30 EDT 2023 | tomdegas
Running a Mydata MY 9 and trying to Restart the machine and try to initiate the hardware, get an error message of F-MOT-MSETDYN X/163: Illegal value of DSP command argument. It seems to be related to the x drive. I've check all the connections on
Electronics Forum | Tue Jul 17 12:57:41 EDT 2007 | cyber_wolf
Is your machine a TP9 2U ? If you have a UFP or a MY series machine this condition usually points towards a bad X-wagon motor.
Electronics Forum | Thu Jan 06 13:56:46 EST 2011 | ev
Thanks for this detail. The X wagon responds as per the instructions here so I'll give the cables a good inspection.
Electronics Forum | Mon Oct 31 02:38:18 EDT 2011 | kenmar
Hi Phil, Thanks I will contact Mydata to see about a possible software upgrade.
Electronics Forum | Tue Apr 04 16:17:27 EDT 2017 | bk
Does your my9 have any cameras aside from the x wagon camera and hydra camera? I believe you need a camera aside from these 2 such as a line scan camera to be able to use the auto teach option.
Electronics Forum | Sun Apr 07 00:45:21 EDT 2019 | d_nguyen2018
Hi, Can you show me how to set up tray table? I have 1 x 10 pockets tape with 10 PQFPs. I went into Magazines then selected Tray Wagon. I did first and last part on the 1 x 10 tape pockets but it did not work. I was told that I must set up the tray
Electronics Forum | Tue Feb 28 07:31:40 EST 2012 | bk
I'm assuming it's your x wagon tranducers that are out of synch. So the first place to start is look at your couplings on both x motors and make sure one of them isn't broken or starting to break. After that i would try swapping out your x board with
Electronics Forum | Mon Oct 25 11:20:52 EDT 2021 | bk
The 245 error is with your x belt motor not the x wagon motor. double check all the fuses on the back of the machine where your power comes in there should be 3 of them. if you haven't changed your blue cables in a while I would change those out. you
.jpg)