Electronics Forum | Thu Apr 16 13:23:41 EDT 2009 | bk
well by the looks of it you have pretty much replaced just about everything that could cause the problem. The only one i haven't seen is the cable going from the computer box up to the x-wagon boards. Just out of curiosity when you took your motor fr
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Tue Apr 02 14:56:30 EDT 2024 | kingkelvin
Hi all - my problem is a bit worse now - I can get all hydra tests to pass in extended service, except indicator levels at current 7 a bit high past 190 limit at ~210-220 - other than that hydra bank re-installs OK - but still it makes a bad hitting
Electronics Forum | Tue Nov 13 12:02:54 EST 2012 | jaimebc
I'll try swaping cards and see if the problem follows the card. So far, my guess would be the motor going bad. I did change the brushes, X wagon cables and every cable that goes to the midas unit. But that didn't fix it. The problem is that to replac
Electronics Forum | Mon May 06 19:21:39 EDT 2013 | amelby
We had that problem on our M12. There were a few > components that had gotten dropped into the > camera area as the hydra head past over it. Our > MY12 has a knob towards the front of the machine > in direct line with the camera. Pulling this
Electronics Forum | Mon May 13 10:08:44 EDT 2013 | rgduval
I've heard that MyData is no longer supporting the TP's, so, getting a new motor might be a difficult proposition. If you can find the motor manuf/part number on the motor itself, you can likely find it on line somewhere...Google the p/n should do i
Electronics Forum | Thu Jul 19 04:23:38 EDT 2007 | chrispy1963
You dont mention if it is ONLY occuring with the A12 or is it other tools as well? Only spring tools or Stiff ones? Regardless of that, the small X Wagon motor is controlled by the track ball and the bigger X Axis motor is controlled by the joystic
Electronics Forum | Fri Sep 02 07:38:13 EDT 2005 | DannyJ
Hi Mike, I haven't tried the 0201s with a Hyrda, but after seeing 20 reviews of your message without a response, I'll try and share my experience with 0402s on a non-Hydra machine. The 0402s are slow, but I managed to get some speed by maxing out
