Parts & Supplies | Pick and Place/Feeders
The Chessel Store purchases original factory excess inventory from various companies that have discontinued products that are still currently active in the field. The purpose of our company is to extend the life of your equipment investment at a much
Parts & Supplies | Pick and Place/Feeders
We purchase original factory excess inventory from various companies that have discontinued products that are still currently active in the field. The purpose of our company is to extend the life of your equipment investment at a much lower cost tha
Electronics Forum | Tue Nov 13 12:02:54 EST 2012 | jaimebc
I'll try swaping cards and see if the problem follows the card. So far, my guess would be the motor going bad. I did change the brushes, X wagon cables and every cable that goes to the midas unit. But that didn't fix it. The problem is that to replac
Electronics Forum | Tue Sep 08 09:37:55 EDT 2009 | cyber_wolf
We are seeing intermittent X-transducer errors. I notice that the X-wagon has more resistance over the Y-wagon area when I manually push it back and fourth. I am thinking the belt might need replaced. Has anyone else seen this before.
Electronics Forum | Tue Feb 28 08:19:03 EST 2012 | cyber_wolf
Replace both of the big X-wagon ribbon cables to start with. You always have to rule those out before looking at anything else.
Electronics Forum | Thu May 13 12:24:26 EDT 2004 | cyber_wolf
We have an older line scan camera on our MY series machine.(The one that uses the X wagon trigger/encoder to turn on the line scan)When I go into the service program and turn the line scan camera to "camera action on" the LED's will only stay lit for
Electronics Forum | Tue Nov 20 15:03:37 EST 2012 | jaimebc
Bruce, Since we had spares, I replaced the X wagon cables, XFMB cable, nothing. FFX Cable, nothing. Swapped mot cards, nothing. Vaccum seal, nothing.At this point I truly believe the problem is either on the theta encoder or the theta motor. Unfortu
Electronics Forum | Wed Apr 15 12:57:37 EDT 2009 | bk
I'm not sure if you fixed your problem yet or not but i'll give you some insight on your problem. The x wagon motor doesn't move cause of the voltage it actually moves when there's current applied to it. The voltage dictates the direction the motor m
Electronics Forum | Wed Jan 05 10:55:12 EST 2005 | OverTheHill
WOW Sr.Tech, 40K worth of bent tools? I'm about ready to be sh*t canned because of 1K's worth. As for trimming the mags, the product is running fine (many boards) and then out of nowhere the tool bends, so I assume my PERFECT operators trimmed the ma
Electronics Forum | Tue Oct 27 12:23:44 EDT 2009 | cyber_wolf
One thing a lot of people don't know is that the small X motor on MY machines have carbon brushes in them. If you do not replace the brushes before they wear out it trashes the motor.
