We have tremendous experience in using various software tools to meet your project requirements. During the development of your product, we work closely with your electrical engineers and mechanical engineers to ensure that the placement of the part
Electronics Forum | Sat Jan 23 15:19:45 EST 1999 | Earl Moon
| Could anyone send me equations to calculate controlled impedance of traces on circuit boards. I am most interested in the buried traces in multi layer boards. | | Thanks, | David - piengr@verinet.com | As one of the first MLB impedance folks on
Electronics Forum | Sun Jan 24 06:44:31 EST 1999 | Kallol Chakraborty
| | Could anyone send me equations to calculate controlled impedance of traces on circuit boards. I am most interested in the buried traces in multi layer boards. | | | | Thanks, | | David - piengr@verinet.com | | | As one of the first MLB impedan
Industry News | 2010-11-24 13:47:37.0
Multitest's board division has successfully introduced a new LCR (layer count reduction) concept for high pin count BGA applications. Board customers now will benefit from significant cost savings without sacrificing performance. With the new LCR concept, the layer count of standard pitch BGA boards can be reduced by up to 40 percent.
Industry News | 2021-05-19 22:36:33.0
Calibration is the process of configuring an instrument to provide a result for a sample within an acceptable range. This process eliminated or minimized factors that cause inaccurate measurements. Although the exact procedure may vary from product to product, the calibration process generally involves using calibration instrument to test samples of one or more known values called "calibrators". The results are then used to establish a relationship between the measurement technique used by the instrument and the known values. The process in essence "teaches" the instrument to produce results that are more accurate than those that occur otherwise. The instrument can then provide more accurate results when samples of unknown values are tested in the normal usage of the product.
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/sonoscan/support/imaging-modes
. Shaded areas indicate the inspection plane. A‑Scan The A-scan is an oscilloscope display of what the transducer sees and is the foundation of creating and interpreting images
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/07/last-will-of-bga-void.pdf
] The SPVC investigation demonstrated that the number of cycles to failure did not correlate with void size. If there was a negative influence of voids the solder joint integrity, Figure 3 would show a cluster of early low cycle failures for larger voids and a cluster of late cycle failures for the small voids