Electronics Forum | Mon Apr 04 09:30:49 EDT 2005 | russ
Andrew, we need a lot more information to help. 1. what is the open caused from? bemt pins, non-wetting, board bowing, or no paste deposited. 2. What is your current stencil design? 3. What does this connector look like and what are the pins? Rus
Electronics Forum | Sat Apr 23 11:30:50 EDT 2005 | Haran
What are the types of Nexlev Connectors available?What are the differences between them.I will be running this component very soon.
Electronics Forum | Sun May 07 19:29:52 EDT 2006 | Dhanish
I am seeing high solder bridging for Nexlev Connector.Can someone advise what are the factors causing Solder Brdiging for Nexlev issues.
Electronics Forum | Wed Oct 29 23:07:42 EDT 2014 | rajz
Help Needed. I face a solder bridging issue on solder mask define pad at edge only for nexlev connector . The pad design such as smd at four corner only. The bridging happen on signal to ground pin only. Current stencil we use 22 round with 6 mils s
Electronics Forum | Thu Oct 30 23:46:20 EDT 2014 | beilimanu
What's the software you are using? Modify it manually. It should not be difficult.
Electronics Forum | Sun Aug 01 11:39:41 EDT 2004 | Andrew
I am seeing high rate of open joint at NexLev connector and also BGA warpage issue with 52 mm Hyper BGA.anyone has the same experience?
Electronics Forum | Tue May 09 22:57:58 EDT 2006 | davef
The NexLev connector is built in a stripline construction, providing a continuous ground plane for each signal contact. The connectors come as tenrow connectors with 100, 200, or 300 positions at possible stacking heights from 10 mm to 30 mm. Technic
Electronics Forum | Tue Sep 13 20:59:26 EDT 2005 | davef
http://www.teradyne.com/prods/tcs/products/connectors/mezzanine/nexlev/modconfig.html
Electronics Forum | Sat Apr 23 13:54:09 EDT 2005 | Indy
I don't know wat are the types.. but wat I can tell you is you need care while profiling them. it needs a peak of around 215-220 if Sn/Pb.. at the ball. So the plastic on top will reach a higher temp. Care must be taken so that it doesn't roast. al