Electronics Forum | Fri Feb 02 13:00:38 EST 2018 | Mike Konrad
Evtimov, no worries. I appreciate your knowledge and contributions over the years. Mike Konrad
Electronics Forum | Thu Feb 01 15:30:26 EST 2018 | davef
I've known Mike Konrad for over 20 years. I like him. He is knowledgeable and generous in the giving of that knowledge. I have no issues with what he said in his vid. We should not get too overly twitchy when someone, sales-type or not, makes an eff
Electronics Forum | Thu Feb 01 15:36:42 EST 2018 | davef
Not to be repetitious, I just don't remember if this has been said or not, I'm old, give me a break. Some people have found that DI water is too thick to properly remove flux residue under low stand-off components.
Electronics Forum | Sat Aug 26 12:26:57 EDT 2000 | Ramon I Garcia C
Hi friends: I have a problem in the process of one PCB, I have a lot of insuficients of solder in top of the board, this pcb already was working good, but sudenly began there isn't flow thru hole, I ran the profile and it was ok, if I inmerse i
Electronics Forum | Wed Mar 24 10:43:59 EST 1999 | Tim
Hi, I have a customer who's electronic assemblies produce RF. He is insisting upon aqueuos cleaning. We switched to a no clean solder years ago and no longer have an aqueous system. Is aqueous cleaning necessary to eliminate 'cross talk' of the s
Electronics Forum | Wed Aug 30 23:45:28 EDT 2000 | Ramon I Garcia C
Hi friends; Steve I'm using flux Kester 959, my top temperature is 187 celcius degrees, my e-mail is ramigary@smtnet.com, Travis I'll check the pcb for contamination, but how may I clean the pcb? may I use alcohol? Nance I cleaned the pipes of the
Electronics Forum | Thu Aug 31 14:27:23 EDT 2000 | Travis Slaughter
How to clean a contaminated board would depend on what it�s contaminated by, alcohol may be just the thing. If there is bare copper that has corroded that could be more of a problem, or maybe not if its due to poor tinning by the board house you coul
Electronics Forum | Wed Aug 30 09:56:37 EDT 2000 | NLykus
Hi Ramon, We have had this problem before on our Seho Wave Solder Machine. We are currently using a spray fluxer as well. By imersing the PCB into the flux you stated you are getting good results. What you need to do is check your spray patter
Electronics Forum | Thu Mar 25 19:29:07 EST 1999 | Graham Naisbitt
| | Hi, | | I have a customer who's electronic assemblies produce RF. He is insisting upon aqueuos cleaning. We switched to a no clean solder years ago and no longer have an aqueous system. | | Is aqueous cleaning necessary to eliminate 'cross ta
Electronics Forum | Mon Mar 29 19:31:29 EST 1999 | Scott McKee
| | | Hi, | | | I have a customer who's electronic assemblies produce RF. He is insisting upon aqueuos cleaning. We switched to a no clean solder years ago and no longer have an aqueous system. | | | Is aqueous cleaning necessary to eliminate 'cr