Electronics Forum | Fri Mar 15 21:20:18 EDT 2024 | compit
Check out Yamaha - also old. A large number of parts (the same machines under the Assembleon, Philips brand), cheap feeders, many parts suppliers. Models from 2 to 16 heads, e.g. Emerald-X can accommodate 84 INDEPENDENT 8 mm feeders.
Electronics Forum | Wed Jun 09 02:35:10 EDT 2004 | Bernard
Base on the PORON foam rubber recommended, is it possible to apply on small BGA chip of 4x4 ball size 0.3mm. Any specific part no and supplier for this type of foam and is it a anti-static material? Would it be possible to punch out at dia. 3mm?
Electronics Forum | Tue Jul 18 11:16:33 EDT 2017 | svfeingold
Found it, it appears to be 15mm. I received a reply from K&S (Kulicke & Soffa) who support the Assembleon machines. They say they do offer full support and training. The support offer is $7,500 per machine for the first year, including: * Annual a
Electronics Forum | Tue Jun 09 07:35:23 EDT 1998 | Steve Gregory
Hi there Gary, Your solder ball problem is very similar the problem I experienced, but I was using a water soluble paste at the time. It started by inspectors telling me that they were seeing cold solder on some SIMM's that we had built regularly. W
Electronics Forum | Mon May 25 20:51:13 EDT 2020 | kylehunter
> A cheap piston compressor (like you might use in > a garage) should be rated such that it has ~50% > duty cycle, you don't want it running > continuously. They are very affordable but do > switch on and off between two essentiall
Electronics Forum | Thu May 21 12:53:38 EDT 2020 | spoiltforchoice
A cheap piston compressor (like you might use in a garage) should be rated such that it has ~50% duty cycle, you don't want it running continuously. They are very affordable but do switch on and off between two essentially hardwired setpoints. The b
Electronics Forum | Sat Sep 23 21:52:51 EDT 2017 | jlawson
In most cases PnP files are all that is needed for SMT program generation. BUT, it depends on origin reference of this data as exported to PnP and could be off in X,Y and rotation of image pending when PnP Data is exported. Also Rotation of parts
Electronics Forum | Tue Jun 09 15:46:29 EDT 1998 | Aric Parr
| Hi there Gary, | Your solder ball problem is very similar the problem I experienced, but I was using a water soluble paste at the time. It started by inspectors telling me that they were seeing cold solder on some SIMM's that we had built regularly
Electronics Forum | Tue Apr 09 21:40:26 EDT 2002 | ianchan
We are a local enterprise with limited resources, just like you described, so hope this experience sharing helps : we place a production Visual Mechanical Inspection (VMI) inspector at the end of each Reflow Oven area, complete with magnify scope 30
.jpg)
