Electronics Forum | Fri May 14 08:30:52 EDT 2004 | pjc
For any application- high-mix, low volume to low-mix high-volume: J.O.T. Automation board handling MPM UltraFlex 3000 printer CyberOptics SE300 3D post print inspector 2x Mydata Synergy II w/ Linear Magazines and Agilis feeders CyberOptics Flex
Electronics Forum | Sun May 10 07:13:38 EDT 2009 | vtech
Hello I would like to know is my decision correct to purchase the following SMT machines for manufacturing of computer Ram modules and Computer Motherbaord. FUJI XP142E PICK AND PLACE FUJI IP3 PICK AND PLAC ELECTROVERT OMNI 7 REFLOW OVEN Also pleas
Electronics Forum | Fri Feb 15 15:55:58 EST 2008 | pjc
This is from the OmniFlo 5 Engineering data sheet: EXHAUST SPECIFICATIONS: STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unload-end: 300 cfm (510 m3/hr) at the 4� (102 mm) stack (minimum req
Electronics Forum | Mon Jan 24 18:41:43 EST 2005 | Chunks
Sorry Pete (and others), they do have em'. Back side of the oven. Open the doors with the power supply switch and it's right next to the power relay. Little digital ones on the Omni Flo series. Nope, our company is selling the ovens and several i
Electronics Forum | Thu Oct 08 22:32:53 EDT 1998 | E.
*Reply to: ericr@nj.tanon.com Without going into a lengthy explaination {at this time}, has anyone experimented, tested, evaluate, and/or 'perfected' an SMT double-side reflow process. Presently I'm using a Kester R593 OA (water soluble) Sn63/Pb37 -
Electronics Forum | Fri Jan 21 19:10:49 EST 2005 | fastek
Allow me to re-state my response. Hours on an oven would be the last thing I would care about if I wanted to know something about it. There is no standard lifespan on heaters, blowers and the like. They can last a year or ten. Sure you can assume a 5
Electronics Forum | Mon Apr 24 14:04:44 EDT 2006 | pjc
You did not tell us where your boards fit on the thermal mass range. That is key. I've run Pb Free low to medium thermal mass boards with good results on a 5 zone oven (5 top/5 bottom). You should not have a problem running a medium thermal mass boa
Electronics Forum | Sat Oct 10 04:58:18 EDT 1998 | Tony B
| *Reply to: ericr@nj.tanon.com | | Without going into a lengthy explaination {at this time}, has anyone experimented, tested, evaluate, and/or 'perfected' an SMT double-side reflow process. Presently I'm using a Kester R593 OA (water soluble) Sn63/
Electronics Forum | Mon Jan 23 03:17:10 EST 2006 | pavel_murtishev
Good morning, IR reflow is yesterday technology. IR heating principle has a lot of issues with heat transfer capability (shadow effect) and uneven PCB heating. To avoid this forced convection ovens were developed. Reflow oven for SMD soldering must
Electronics Forum | Wed Sep 27 15:57:33 EDT 2006 | SWAG
I wanted to post resolution on a reflow oven problem we had but can't seem to search out the old thread. So, this is new but old. Our OmniFlo 7 conveyor was stopping every once and a while and the speed indicator on screen said 1000+ ipm. We cle