Electronics Forum | Mon Nov 08 06:37:19 EST 2004 | zzikester
If your in the UK call Contax 01489 885808, they sell the Omniflos and they will answer your questions.
Electronics Forum | Wed Apr 16 09:30:09 EDT 2008 | swag
IPC-7530 might help some but will cost you a little. We have an older OmniFlo that has a pretty good section on all that in the manual if you happen to have one of those.
Electronics Forum | Thu Sep 04 02:43:09 EDT 2008 | benefon
Thanks This error only occurred with one oven profile with the reflow zone temperature set at 270�C. Perhaps it really has to do with the exhaust pull as the oven is operating very near its temperature limit with this profile. I will check that. Tha
Electronics Forum | Thu Sep 18 11:07:39 EDT 2003 | donbell
SR. Tech: I have worked with Omniflo 7 and 10 ovens for many years. I purchased several 10 zone ovens in '98 when I worked for Ericsson. Here are some of my experinces with Electrovert Omniflo ovens; Yes, you can expect to run the conveyor speed a
Electronics Forum | Wed Aug 09 11:45:25 EDT 2006 | SWAG
We have an OmniFlo 7, 2000 vintage reflow. We are having conveyor problems. I checked the encoder and speed control board and everything is good per tech. manual operations. We removed the chains a couple months ago and thoroughly soaked/cleaned t
Electronics Forum | Thu Feb 02 12:39:41 EST 2017 | mnorthey
We have been using Vitronics for over 20 years with very few problems. I imagine Heller is just as good, I would rather you talk to your Solder provider Rep to find out about any add-ons you need for your specific processes. Along with that info and
Electronics Forum | Mon Nov 17 18:40:10 EST 2003 | Ray Wilson
Advanced electronic assembly convection reflow ovens include a variety of options for cooling product after reflow. The Electrovert Omniflo series ovens include options for internal or external cooling systems. What are the pros and cons of utilizin
Electronics Forum | Fri Aug 01 10:24:04 EDT 2008 | edmaya33
Hello Reflow Masters; I'm using an Omniflo-10E reflow oven. Due to high demands of our production in lead free process, can I use my existing leaded line as an native? Does this option affect the lead contamination of the solder in Pb-Free to go bey
Electronics Forum | Thu May 14 10:00:14 EDT 2015 | swag
I like MpM personally - run forever and programming is easy and leads you through it. It's hard to miss a step of programming with MpM software. DEK's a little harder (for me) but still very nice controls. The pluses of DEK - DEK has a high freque
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
