Electronics Forum | Mon Jul 15 18:11:36 EDT 2019 | slthomas
First question - is your company already compliant with and/or certified to AS9001? If not, is your company compliant with and/or certified to ISO 9001:2015? There are several overlapping requirements. If the answer is no to the previous and you pla
Electronics Forum | Tue Apr 07 19:11:55 EDT 2020 | SMTA-Gregory
Our operations are deemed essential and our manufacturing operations continue. All employees that can work from home are to. As far as employees that need to come in to the manufacturing plant that consists of multiple buildings, an specific entran
Electronics Forum | Mon Jul 14 12:11:17 EDT 2014 | rgduval
We used to use the Tapesplicer tool available from http://www.tapesplice.com (Sierra Electronics), in a high mix, low volume environment with MyData's (older feeders). Short review: It worked. Longer review: First, technique is everything. Splicin
Electronics Forum | Wed Dec 13 12:08:57 EST 2000 | Stefan Witte
Apparently the adhesive tape peels off from the joint, which could have some reasons. 1. There should be an overlap of the cover tape, as Cal mentioned. The new cover tape laying over the old by approx. 2mm. I also peel the cover tape a bit off, whi
Electronics Forum | Wed May 24 15:45:38 EDT 2000 | JAX
John, Would you enlighten us to what machines you are talking about. I have never heard of such things. Typically, machines map out the boards with the locations of the fiducials relative to there CAD locations in order to account for stretch. Local
Electronics Forum | Tue Jan 30 21:15:51 EST 2001 | davef
You seem to pretty far from shore to begin thinking about boats and floatation devices. Most laser trimmers are used by: * Semiconductor fabricators * Resistive component fabricators * Hybrid circuit assemblers Component fabricators and hybrid [
Electronics Forum | Wed Dec 29 18:01:13 EST 1999 | JAX
What's happenin Larry, I am not sure if bump proccess E is available on this particuliar software rev. but I have forgotten?????? It shouldn't matter; bump proccess A will work fine. The only things you have to do is make sure the pick up point
Electronics Forum | Fri Apr 11 09:36:55 EDT 2003 | davef
We don't know anything about using "old Tango for DOS". First, consider the fabricator of your part as the THE most appropriate place to look for layout recommendations. We've discussed the heirarchy of sources for layout information previously he
Electronics Forum | Thu Mar 24 22:39:22 EST 2005 | pmd
My opertaors have lots of setup problems with vib feeders. They dont realize that the chip weight pushes parts down and when feeders run low it's the frequency that drives the parts. Mixing parts with diferant phisical deminsions and masses in the sa
Electronics Forum | Tue Jun 14 08:37:18 EDT 2005 | jdumont
Morning all, just took a look at a new board we just got in and the there are different pad areas under the same BGA. What happened is engineering uses wider trace sizes for some pads and those overlap when more than one go to the same pad. This caus
.png)
