Electronics Forum | Wed Sep 09 09:38:53 EDT 2009 | patrickbruneel
Dave is correct (as usual). Baking the boards might reduce blowholes but will definitely not eliminate the problem. Back in my hay days we had a huge problem with blowholes and we baked boards 24/7 with very little success in reducing blowholes (ev
Electronics Forum | Tue Jun 13 12:00:15 EDT 2000 | Brian Larson
How long and at what temperature to you bake through-hole boards for moisture? I am getting blow holes after the wave solder. Everything points to the drilling of the board, but I need to prove that it is not moisture.
Electronics Forum | Mon Apr 07 15:14:41 EDT 2014 | garym4569
I drilled a small hole from the other side in order to get my thermocouple under the inductor pad. I did not have anything on hand to fill the hole, so I covered with kapton tape the best I could. I suspect that is why it looks like it should work.
Electronics Forum | Fri Jul 30 16:41:14 EDT 2004 | Dave
Consider a 6 layer board. The Through via gets drilled from top layer to bottom layer. All 6 layers has the hole drilled in it. A blind via is a via that does not got through the entire 6 layers. It would go from layer 1 to layer 2. or layer 6 to lay
Electronics Forum | Mon Jun 18 19:37:02 EDT 2001 | Gil Zweig
You can use your x-ray inspection system to QC incoming multi-layer printed circuit boards. In particular you would want to insure drilling registration. A drilled, plated through hole, precipitously close to a ground plane can have , in time, copper
Electronics Forum | Wed Apr 10 22:23:48 EDT 2002 | davef
IPC-6012A, 3.4.1 has words to the effect of: Hole size tolerance and hole pattern accuracy shall be as specified in the procurement documentation. Our fab says: Standard Drill Sizes Drill Number ||Hole Size ||Finished Hole Size 70 ||0.028" ||0.02
Electronics Forum | Wed Apr 10 22:24:30 EDT 2002 | davef
IPC-6012A, 3.4.1 has words to the effect of: Hole size tolerance and hole pattern accuracy shall be as specified in the procurement documentation. Our fab says: Standard Drill Sizes Drill Number ||Hole Size ||Finished Hole Size 70 ||0.028" ||0.02
Electronics Forum | Mon Jun 18 01:23:07 EDT 2001 | gregH
I have a 10-pin single in line connector that is reflowable. Pin size is 1.0mm and my pcb drill size diameter for the pin is 1.5mm. is it okay for pin in hole process ? I have only 2 pcs of pth components and they are the 2 10 SIL connectors. What's
Electronics Forum | Thu May 03 09:02:31 EDT 2007 | realchunks
Hi LC, Where are you getting your profile from? Are you actually attaching t-couples to the board? For BGAs the best place to measure is from the center of the device. This means drilling a hole in the board and placing the t-couple thru the hole
Electronics Forum | Tue Dec 14 01:05:09 EST 1999 | cklau
Hi All I have a 0.7 mm diameter hole for vias, what�s the minimum annular ring for this hole diameter? Ans: Fur inner layers Min = .006" hole-pad annular ring ; inner pad dia - hole dia/2 For outer layers Min = .005" hole-pad annular ring ; outer p
