New Equipment | Assembly Services
The board is designed by customer and it's for Mobile Phone. We did one-Stop EMS Service for this project (PCB manufacture, components sourcing, SMT and THT assembly): Product name: 6 Layer PCBA board Material: FR-4 TG180, Shengyi Thicknss: 1.0mm Su
New Equipment | Assembly Services
The board is designed by customer and it's for Network interface controller. We did one-Stop EMS Service for this project (PCB manufacture, components sourcing, SMT and THT assembly): Product name: 8 Layer HDI PCBA board Material: FR-4 TG180, Shengy
Electronics Forum | Fri Nov 03 07:28:27 EST 2006 | davef
Via filling methods are: * Tenting * Plugging * Capping * Flooding Tented Via. A via covered with dry film soldermask; the via is not filled. When tenting from both sides there may be issues with trapped air that expands during mass soldering. Plug
Electronics Forum | Tue Jan 31 15:52:39 EST 2006 | russ
I have never related Solder mask layout to Black Pad. I don't see how they could be related but.......
Industry News | 2018-10-18 10:40:04.0
Via Tent-Holes with Solder Mask
Industry News | 2018-05-22 12:19:27.0
IPC – Association Connecting Electronics Industries® would like to announce the release of additional test coupons for the IPC-2221B Gerber Coupon Generator, an exclusive annual subscription service for IPC member companies. The IPC-2221B Gerber Coupon Generator subscription service is the only service providing new, industry approved test coupons addressing blind, buried, stacked and staggered via structures. The most commonly used coupons for product acceptance are “AB,” “AB/R” and “D” which were introduced in 2016.
Technical Library | 2019-05-29 01:47:22.0
1.Vias near SMD pads: Solder can flow into the via after melted. As a result cold joint will appear in the end. Check the picture below. 2.Vias on SMD pads: Solder can flow into the via more easier after melted. Check the picture below. 3.Via opening without soldermask covered. When workers solder TH parts by hand, soldering iron can touch vias sometime, then tiny amounts molten solder will stay on vias. This can lead to electrical short easily. We recommend you make all vias tenting (covered by solder mask) if it is possible.
PCBNPI-Professional PCB Fab/PCB Assembly Service Provider From China
With the development of miniaturization of assembly components, the layout area and pattern design area of PCBs have also been continuously reduced, and PCB manufacturers are constantly updating the production process to conform to the development tr
| https://www.eptac.com/wp-content/uploads/2015/02/eptac_03_18_15-1.pdf
Imagineering, Inc. | https://www.pcbnet.com/blog/how-pcbs-are-made/
: Copper is used to create conductive pathways on the PCB. Solder Mask: This is a protective layer, typically made of epoxy resin. It’s applied to certain board areas to protect them from the soldering process. Silkscreen
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
