Electronics Forum | Fri Aug 20 10:49:37 EDT 2010 | cobar
Article to assist with Stencil Design Guidelines http://shanelo.co.za/technical_paper_about_stencil.htm
Electronics Forum | Thu Aug 08 15:16:03 EDT 2002 | OhioD
A "Pumpprint" stencil refers to a thick DEK stencil with pockets routed-out on the underside, so it will clear any THT leads, paste/glue deposits, etc., and not squish them. It's called pummprint because it was developed to use the ProFlow-type head
Electronics Forum | Tue Aug 06 11:07:37 EDT 2002 | slthomas
OK, I'll bite. How you can set a stencil down on a printed board and run a squeegee across it (even if it's a proflow head, it's still a squeegee, right?) without disturbing the printed paste?
Electronics Forum | Thu May 30 09:14:03 EDT 2013 | emeto
I have another idea. Would you check the apertures on the stencil? May be they didn't cut the right size apertures there. If you have smaller aperture you can't get the right amount of paste.
Electronics Forum | Fri Apr 30 19:22:57 EDT 2021 | compit
After printing or after the oven? Too much paste - thinner stencil, smaller holes, to rare paste ...
Electronics Forum | Sat Aug 03 08:44:11 EDT 2002 | P. Kannan
We are having 3 MPM UP-2000 printer & 1 AP-25 printer with us. I would like to have the technical guidance for my following application. For one of our model, there is a requirement of Glue & solder paste on same side of the PCB. Currently we are u
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
