Electronics Forum | Thu Feb 12 17:21:07 EST 1998 | Justin Medernach
| I would appreciate any information concerning the wash and bake of blank Printed Circuit Boards | before assembly. | + Is it necessary to wash and bake PCB�s before assembly? | + If any, what is the reason for wash and bake of PCB�s? | + If any, wh
Electronics Forum | Tue Jul 06 05:33:46 EDT 2004 | ANDREW
1)What is the MSD level for PCB? 2)I have some PCB's with HIC (humidity indicator card ) has turn to pink at 50%. Should I bake the PCB prior to assembly process.This fab is a complex board with various kind advance package assembled on the board.
Electronics Forum | Wed Aug 14 13:54:54 EDT 2002 | DenM
Larry, You can try one of two approaches, a bake above 100C will drive off moisture or use a vacuum bake. The vacuum bake process is slow since there is less/no air to conduct the heat. In the hybrid industry the standard vacuum bake was 16 hours at
Electronics Forum | Fri Jul 30 17:26:02 EDT 1999 | John Thorup
| | Surface Mount Components like QFP's in Tray usually comes sealed in an anti-static plastic pack. In case the QFP's were removed from the said anti-static bag for more than 2 weeks, do these components needed to be baked for they might produce so
Electronics Forum | Tue Oct 31 01:32:47 EST 2006 | hanocete
thanks for your reply, actually we bake the PCB assembly prior the rework because the package was exposed for quite some time already. The baking time was 24hrs @ 125 deg.C. We notice that there were flux residues on the connectors after the baking.
Electronics Forum | Thu Aug 05 05:28:03 EDT 2004 | Bryan
There 's one thing I'm not sure...For the OSP board finish whether we could bake and then store this kind of PCB?or whether once we opened the vacumm package of OSP board and then we can't bake it ? Thanks Bryan
Electronics Forum | Thu Aug 09 09:05:09 EDT 2007 | davef
There are no requirements acceptance criteria for baking of board assemblies. What are your customer requirements? The common reasons people choose to bake PCB are to prevent: * Delamination of multilayer boards * Measles, particularly on double si
Electronics Forum | Fri Jun 01 04:05:25 EDT 2012 | grahamcooper22
If you think the root cause is excess moisture in the pcb then try to bake it for longer. Even longer then the manufacturers recommendation. It takes a long time for excess moisture to come out of a pcb. Try 24 hours , then 36 hours and see if there
Electronics Forum | Thu Feb 24 14:58:11 EST 2000 | Greg denham
Does anyone have any information on baking boards to remove moisture before reflowing and waving assemblies? I've been told that we should do this to stop such problems as delamination of boards, blow holes, solder balls, etc. I don't know have any e
Electronics Forum | Thu Feb 24 18:08:42 EST 2000 | Travis Slaughter
Baking boards, especially multi layer, will help with blowholes and delimitation, but not with solder balls. Normally about 120c for 1 hour or so is sufficient. I usually will not go to this trouble unless a board has proven to be a problem or if th
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830