Electronics Forum | Sat Feb 05 13:25:32 EST 2005 | etienne
Just a basic suggestion.... Inspect the nozzle placing the component...because that is the only medium, apart from the PCB design, which can be causing the damage. It occurred in my Department.
Electronics Forum | Thu Nov 03 00:14:11 EDT 2022 | bin4ry2
Can anyone help to identify this little tan/brown colored pcb part? (The one labeled GND) I believe it's called an SMD ceramic capacitor but could certainly be incorrect. There don't appear to be any marking on it so beside the tan color, picture qu
Electronics Forum | Fri Apr 11 14:53:50 EDT 2003 | MA/NY DDave
Hi A lot of good answers. "No verification was done on the part as it was deemed to be a "straight replacement". Sound familiar?" Yes this sounds familiar, yet I am never sure it is a new supplier or component problem. It could be that the old par
Electronics Forum | Mon Jul 23 10:56:38 EDT 2018 | dleeper
I've never seen this before and I would be suspicious. Have you tried to dust it off with a brush or Q-tip, it might just be some sort of process contamination. Have you looked at the reel to see if the parts are coming in with these spots from the
Electronics Forum | Wed Jan 13 04:27:00 EST 2016 | crystalpcb
Hi Here is our factory production capability: Shenze Electronic PCB Specification Layer Count 1 to 35 Layers Material Brand Shengyi,KB,GRACE,ISOLA,Rogers,Taconic,ARLLON,Bergquist Base Material FR-4(TG135,TG150,TG170,TG180),Halogen Free FR-4,Ceramic
Electronics Forum | Thu May 24 07:09:04 EDT 2007 | aj
Any advice with using this type of PCB material would be welcome. aj...
Electronics Forum | Fri Jun 25 03:42:29 EDT 2010 | grahamcooper22
Do you have to 'break' the pcbs from a panel or biscuit or are they individual pcbs form the start ? Poor pcb separation techniques or processes will damage ceramic caps.
Electronics Forum | Fri Jun 06 06:11:18 EDT 2014 | paulg
I have a large monoblock ceramic filter on a PTFE based pcb material. The filter has a metal casing soldered onto the ceramic filter. I am concerned that if the heating rate is to rapid, then thermal shock / differential expansion could cause the fil
Electronics Forum | Fri May 25 08:06:19 EDT 2007 | davef
Soldering PTFE boards * Exposure to the high temperatures needed for solder reflow poses no problem of loss of peel strength since the exposure times are relatively short. * There are many different types of PTFE based products that may perform diff
Electronics Forum | Mon Jul 12 00:20:11 EDT 2010 | leadthree
After a detailed check the cracking was most likely from the ICT and a variation in the length of the probes (due to wear and tear) that press down the PCB. I am very certain that was the reason.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830