Industry News | 2018-10-18 09:37:27.0
How To Set Profile In SMT Reflow Oven
Electronics Forum | Wed Mar 31 01:25:16 EST 2004 | amil
dear all, we prepare ourself to assembly IMS board The PCB design with V cut How to depanelisy it? With scoring machine or manual breaking? Any experience Thanks G�bor
Electronics Forum | Tue Feb 23 10:33:40 EST 2010 | andrzej
To prevent cracking SMD components near the edge of PCB you should use guillotine for V-cut groove. Other solution is redesign panel of PCBs and in critical areas you should mill along the outline instead of V-cut, but if you choose this way probabl
Electronics Forum | Wed Feb 05 05:29:33 EST 2003 | Rajinder Sharma
If you are facing problem of craked capacitor only after breaking of the panel into individual PCB's, this may be due to stress being generated on the capacitors terminals. The stress may be due excess pressure being applied on the panel for breaking
Electronics Forum | Sat Feb 05 13:25:32 EST 2005 | etienne
Just a basic suggestion.... Inspect the nozzle placing the component...because that is the only medium, apart from the PCB design, which can be causing the damage. It occurred in my Department.
Electronics Forum | Mon Mar 03 05:35:21 EST 2003 | Kelly
We just had this issue a couple months ago with a single sided FR-4 board which was scored. We found that the design was a factor but also the depth of the v-score. Since then we have re-designed the part further away from the score line. At the same
Electronics Forum | Wed Feb 08 09:43:08 EST 2023 | charles_nguyen
Thank you for the above information but what I want to talk about is the PCB design aspect. Should there be any warning about it in the DFM?
Electronics Forum | Sun Oct 09 11:16:06 EDT 2016 | mekmat
Hello, I would like to ask you about the minimal distance between components and border of pcb especially V-cut to avoid crack of component during depaneling? I need some standard (IPC or something) where is this defined? Thank you for your support
Electronics Forum | Tue Nov 01 12:28:36 EDT 2016 | comatose
It depends. Are you hand breaking them, rotary knife or linear knife? Hand break you want to be about 5mm (and it isn't a great practice even then) with a rotart knife you want to keep parts probably 3mm, especially capacitors. With a linear knife we
Electronics Forum | Thu Aug 31 04:25:03 EDT 2000 | Chris May
Dougie, If you have square, rectangular etc; shaped PCB's maybe you could have routing between circuits. "V" shaped grooves top and bottom. I found this extremely good especially if the assemblies are wave soldered. No gaps for flowing up and over.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
