Electronics Forum | Mon Nov 12 10:57:36 EST 2001 | emmanuel
We are to use a PBGA 272 and a PBGA 388. Between 500 and 750 thermal shocks (-45�C/+125�C), we have noticed that some cracks appear in the solder joints. According to our component specialists, these cracks are due to the whole design (pcb, component
Electronics Forum | Mon Sep 06 04:42:18 EDT 2004 | KenF
Thx for the replies. Acutally I am doing a process related study to see whether the process (pcb depanelling)can induce crack to an MLCC. After depanelling, I will do a thermal shock on the MLCC based on IEC 384-1, that is, five cycles of 30min at hi
Electronics Forum | Tue Nov 01 09:57:18 EST 2005 | Chris
Hi, I am experiencing cracked solder joints on ceramic resonators after the ultrasonic plastic weld process. PCB assy is placed into plastic housing and then housing halves are ultrasonic welded. Not a soldering problem. I know this component is
Electronics Forum | Thu Oct 25 04:58:58 EDT 2007 | wayne_
I think the not fully melted BGA ball is the main problem. The middle of the BGA IC...the ball not fully melted....when it subjected to heat and cause PCB warpage....the partial melted joint in the middle part of the BGA started to crack...bcos of we
Electronics Forum | Thu Jan 08 10:56:13 EST 2009 | aj
Hi, Is there any PTH Assembly after reflow, we found cracked joints on some BGAs which was caused by operators ing Oupin connectors which were a tight fit. This caused the PCB to flex hence cracking joints. One way of checking for this during test
Electronics Forum | Fri Oct 15 11:03:50 EDT 2010 | hegemon
Well, we got the baking part right at least. I would think that would help to rule out the barrel cracks allowing moisture escape. Plating too thin makes sense to me. In any case, do you think barrel cracking would be observable on a bare PCB?
Electronics Forum | Wed May 22 10:14:08 EDT 2019 | emeto
Matt, we did the study and YES perpendicular to the V-score is the worst case scenario. We did a cross section and confirmed component is cracked. If you don't have power over PCB design, the easiest way is to change board panelization or even order
Electronics Forum | Wed Sep 07 10:34:52 EDT 2005 | PWH
Have experienced this on a few different cap. parts. Agree with other postings. Following are solutions to problems we have had: 1) Cracked cap too close to board edge per IPC spec. Designer replaced part with 3 caps in series to eleviate stress
Electronics Forum | Tue Feb 02 12:31:26 EST 1999 | John
| I have a product using high temperature solder to connect terminal pins to a PCB. The board is single sided copper, no plaiting. The solder is 95% tin 5 % silver. The flux is low activity rosin. The product is a subassembly. When the product i
Electronics Forum | Mon Feb 01 16:40:45 EST 1999 | Dave Waddick
I have a product using high temperature solder to connect terminal pins to a PCB. The board is single sided copper, no plaiting. The solder is 95% tin 5 % silver. The flux is low activity rosin. The product is a subassembly. When the product is
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
