Electronics Forum | Wed Sep 01 14:59:12 EDT 2010 | eezday
I've been working to bring a Universal GSM-1 back to operational readiness at a university. I have lots of pnp experience but little on the GSM. The software is at 3.2.3. When I try to manually "zero the board" in the PWC menu I get only a black s
Electronics Forum | Tue Mar 08 09:57:04 EST 2016 | rgduval
Make sure that your fiducials are selected to be used for global correction. I've had this problem with our machine running OS2, and in the UI for that, you have to select the fiducials in the fid screen, and then there's a menu option to select the
Electronics Forum | Thu Jul 25 14:05:12 EDT 2002 | Bordiky
I've been reading the forum here for a few weeks and found some helpful material from talented individuals. Now, I have a question(s). I'm looking into different alternatives for doing X outs. Right now I'm familiar w/ two of them:1. Bad Board Mar
Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
Electronics Forum | Thu Aug 22 04:08:17 EDT 2002 | Jason Baldwin
Symptom: Board Stuck on Print Conveyor error messages. Cause: Board not flagging the camera sensor. Remedy: Check the following items: � Check the camera sensor can see the board underneath. � Check the camera sensor calibration (in Tools, Camera Re
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Mon Mar 03 12:25:37 EST 2008 | daxman
The problem was first noticed while doing a nozzle center. The wide angle camera would not display an image. After rebooting the machine (sometimes it took several tries) the camera would work. A few months later, the wide camera would not boot at a
Electronics Forum | Tue Dec 20 16:47:22 EST 2005 | toml
Parameters -> Cameras) Look at the camera serial tag and you should see C4 or OAL or C4 OAL. Make sure the camera type is set to strobed RS170 (C4) or whatever type you have. Then set defaults for this camera, and power cycle. This will fix the f
Electronics Forum | Fri Sep 22 14:07:29 EDT 2006 | realchunks
I think Sr is right. Miss prints are prolly a result of your tooling moving the board after the camera looks at the fids. It also could be the camera itself hitting the board from warpped board or tooling raising the board up. It may be the camera
Electronics Forum | Fri Aug 22 02:10:55 EDT 2014 | mdang
I wonder if anyone can help me with this problem. My FUJI CP65 with 0201 camera is working fine for a while. Now, it starts losing the vision on 0201 camera. The system will run for a while then I don't see the part on the part monitor when the nozzl